DS Produkte 04239 Talimatlar Kılavuzu - Sayfa 3
Ev Aydınlatma Aksesuarları DS Produkte 04239 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. DS Produkte 04239 6 sayfaları. Led candles
EN
■
Take the batteries out of the articles when they are dead or if
the articles are not being used. This will prevent any damage
if a battery leaks.
■
The batteries must not be recharged or reactivated by other
means, dismantled, thrown into a fi re, immersed in fl uids, or
short-circuited.
■
Protect the articles from heat sources (e.g. grills), strong tem-
perature fl uctuations, direct sunlight, impacts and persistent
moisture.
■
Keep the articles out of the reach of children and animals in a
dry place that is protected from direct sunlight.
■
Do not use any caustic or abrasive cleaning agents for clean-
ing. These could damage the surface.
Items Supplied
3 x LED candle
1 x remote control incl. CR2025 lithium button cell (3 V)
3 x 1.5 V batteries of the AAA type are required per candle.
These are not supplied with the articles.
Putting into Operation
Candles
1. Unpack the items supplied and check them for completeness
and for possible transport damage. In the event of transport
damage, please contact the customer service department.
2. Remove any protective fi lms and stickers.
3. Open the battery compartment on the bottom of the candle:
turn the cover anticlockwise a little and take it off.
4. Insert three batteries (1.5 V, AAA type). Ensure the correct
polarity (+ / –).
5. Slide the switch next to the battery compartment to the ON
position to switch on the candle.
6. Put the cover back on and turn it clockwise to secure it in
place. When you do this, make sure that the locking lugs sit in
the recesses which are provided for them.
7. Open the cover again and slide the switch to the OFF position
to switch the candle off again.
If the performance of the candles diminishes, the batteries should
be replaced.
Remote Control
The battery is already inserted and provided with a transport se-
curing device when the article is supplied. Remove the protective
strip before you fi rst use it.
1. Open the battery compartment on the back of the remote con-
trol.
2. If necessary, remove the used battery and insert a new 3 V
lithium button cell (CR2025 type). Pay attention to the correct
polarity (+ / –).
3. Shut the battery compartment again.
The candles can be switched on and off using the remote control.
1. Press the ON button on the remote control to switch on the
candles.
2. Press the OFF button on the remote control to switch off the
candles.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
Instructions
Customer Service / Importer:
*) Calls subject to a charge. Costs vary depending on the provider.
All rights reserved.
Troubleshooting
Problem
Possible cause / solution
•
•
The candles do not
•
react to the remote
control.
•
Technical Data
Article number:
Model number:
Voltage supply:
– per candle:
– Remote control:
Disposal
Dispose of the packaging material in an environmentally
friendly manner and take it to a recycling centre.
Dispose of the device in an environmentally friendly manner
at a recycling centre for used electrical and electronic devic-
es. More information is available from your local authorities.
Batteries should be removed prior to disposal of the device
and disposed of separately from the device at suitable col-
lection points.
✆
+49 38851 314650 *)
3
Article number: 04239
Has a battery been inserted in the
remote control?
Are batteries inserted in the candles?
Are the batteries too weak or incor-
rectly inserted?
Are the candles within the range of
the remote control?
04239
F2472
4.5 V DC (3 x 1.5 V batteries, AAA type)
3 V (1 x CR2025)
Z 04239 M DS V1 1117