DSC PC 1500 Kullanım Kılavuzu - Sayfa 2
Güvenlik Sistemi DSC PC 1500 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DSC PC 1500 9 sayfaları. 4 digit master code
Entry Delay Off Arming
If you wish to arm your system and eliminate the entry delay, enter [
before your access code. The "Armed" light will flash as a reminder that the
system is armed and has no entry delay. An entry through any zone
programmed as a delay zone will create an instant alarm.
e.g. To arm without entry delay, press [
Disarming the System
Enter the premises only through the door(s) designated by your installer as
the entry door. Entering by any other door will sound an immediate alarm.
As soon as the entry door is opened, the keypad sounder will come on to
indicate that the system should be disarmed. Go to the keypad and enter
your four digit access code. If an error is made entering the code, press
the [#] key and enter your code again. As soon as the correct code is
entered, the "Armed" light will go out and the keypad sounder will silence.
The correct access code must be entered before the entry time expires.
The entry time delay may be changed by your installer. If an alarm
occurred during the period the system was armed, the "Memory" light and
the zone light of the zone that caused the alarm will flash for two minutes.
After the two minute period, the "Memory" light and zone light will stop
flashing and the panel will return to the ready state. Pressing the [#] key
during the two minute period will cancel the alarm memory display.
If a trouble is present when the panel is disarmed, the "Trouble" light will
come ON (See Viewing Trouble Conditions section to determine the source
of the trouble.) Note that troubles will not display while the system is in the
Alarm Memory Display Mode.
If you return home and find that an alarm has occurred while you were
away, it is possible that an intruder may still be on the premises. Go to a
neighbour's house and call the local police to investigate.
Quick Arm Feature
When the Quick-Arm feature is enabled, the system may be armed simply
by pressing [
*
][0] instead of the 4 digit access code. This feature allows a
person to arm but not disarm the system.
Enter [
*
][6][Master Code][4] to turn the Quick-Arm feature ON and OFF.
When the command is entered, the keypad buzzer will beep 3 times if
Quick-Arm is being enabled and will sound one long beep if it is being
disabled.
Press [#] to return to ready.
Door Chime Feature
The door chime feature is used, while the panel is disarmed, to provide a
tone from the keypad each time a door or window is opened or closed.
The doors and windows which will provide this indication are programmed
by your installer.
*
Enter [
][6][Master Code][6] to turn the door chime feature ON and OFF.
When the command is entered, the keypad buzzer will beep 3 times if the
door chime feature is being enabled, and will sound one long beep if it is
being disabled.
Press [#] to return to Ready.
*
][9][access code]
3
*
][9]