DSC PC2525 Kullanım Kılavuzu - Sayfa 13

Güvenlik Sistemi DSC PC2525 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DSC PC2525 17 sayfaları. Dsc pc2525 security system instruction manual
Ayrıca DSC PC2525 için: Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (16 sayfalar), Kullanım Kılavuzu (13 sayfalar)

Sayfayı Yazdır

TESTING AND MAINTENANCE

Bell Test

Entering this command will sound the siren and turn ON all the keypad lights for 2 seconds. To perform

a bell test, enter [ ][6][Master Code][8] on the keypad.

Weekly Testing

It is recommended that you test your system weekly.

1 Inform the monitoring station that you are testing your system.

2 Disarm the system and ensure that the "Ready" light is ON.

3 Perform a Bell Test by entering [ ][6][Master Code][8]. The bell or siren will sound for 2 seconds

and all of the lights on the keypad will come ON.

4 Activate each sensor on your system in turn. For example, open protected doors and windows, and

walk in areas protected by motion detectors. Each Zone Light should come ON when each zone is

activated. Each Zone Light will be shut OFF when the zone is restored to normal (when the door or

window is shut, or when motion stops in areas protected by motion detectors).

5 If they are programmed for operation, press the [F], [A], and [P] keys in turn. The [F] key will sound

the bell or siren in a pulsed mode. Enter an Access Code to silence the alarm. The [A] key is a silent

alarm; the [P] key may be programmed as silent or audible. If an alarm sounds, enter an Access

Code to silence the alarm.

6 If the system features a fire zone, activating the smoke detector or other fire detection device will

cause the bell or siren to sound in a pulsed mode. CAUTION:

materials to test a smoke detector. Contact your installer for instructions on safe methods of

activating a smoke detector.

7 Should the system fail to operate properly, call your alarm dealer for service.

8 When testing is complete, call and advise the monitoring station.

Maintenance

With normal use, your system requires a minimum of maintenance. The following points should be

observed:

1 Do not wash the keypad with a wet cloth, and do not use household cleaners, such as glass cleaners,

on the keypad. Light dusting with a cloth slightly dampened with plain water should remove normal

accumulations of dust.

2 For other system devices such as passive infrared, ultrasonic or microwave motion detectors,

glassbreak detectors or smoke detectors, consult the manufacturer's literature for testing, cleaning

and maintenance instructions.

3 It is recommended that the back-up battery be replaced every three years. Contact your installing

company for information on replacing the battery.

CAUTION:

CAUTION: Do not use an open flame or burning

CAUTION: