DSC PC5010 V2.0 Kullanım Kılavuzu - Sayfa 5

Güvenlik Sistemi DSC PC5010 V2.0 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DSC PC5010 V2.0 18 sayfaları.

Alternate Arming Methods

Away Arming

Arming the system in the Away mode will have all interior zones and perimeter zones active. If motion

is detected in the interior zones, or if one of the perimeter zones is violated, the alarm sequence will

begin. To arm in the Away mode, enter your access code and exit the premises through a designated

Exit/Entry door. The system will recognize that occupants have left the premises. Once the exit delay

expires, the system will be fully armed.

Audible Exit Fault

In an attempt to reduce false alarms, the Audible Exit Fault is designed to notify you of an improper

exit when arming the system in the Away mode. In the event that you fail to exit the premises during

the allotted exit delay period, or if you do not securely close the Exit/Entry door, the system will notify

you that it was improperly armed in two ways: the keypad will emit one continuous beep and the bell or

siren will sound. If this occurs, you must re-enter the premises, enter your access code to disarm the

system, and then follow the arming procedure again, making sure to exit the premises in the proper

fashion. Your installer will tell you if the Audible Exit Fault has been enabled on your system.

Stay Arming

This feature, if enabled by your installer, will allow you to arm the perimeter zones while leaving the

interior zones inactive so that you can remain on the premises while the system is armed. When you

enter your security code to arm the system and do not exit the premises through a designated Exit/

Entry door, the system will arm in the Stay mode, automatically bypassing the interior zones.

The interior zones can be reactivated at any time by entering [ ][1] at any keypad. If you reactivate the

interior zones, be sure to only inhabit areas not covered by motion detectors. To access areas

protected by motion sensors, you must enter your security code and disarm the system.

Arming Without Entry Delay

If you wish to arm your system without the entry delay, enter [ ][9] then your access code. The Armed

light will flash as a reminder that the system is armed and has no entry delay. An entry through any

zone programmed as a delay zone will create an instant alarm.

Quick Arm

When the Quick Arm feature is enabled, the system may be armed by simply pressing [ ][0] instead of

your access code. Please note that pressing [ ][0] will only allow you to arm the system; to disarm,

you must enter a valid access code. Your installer will inform you if the Quick Arm feature has been

enabled on your system.

Quick Exit

When the Quick Exit feature is enabled, pressing [ ][0] while the system is armed will provide a two

minute window for you to exit the premises. During this time, you may only open and close the

designated Entry/Exit door once. Once the door is closed, the panel will end the two minute quick

exit delay. If the door is opened again, or if the door is not closed after two minutes, or if another zone

is opened, the panel will begin the entry delay. Your installer will inform you if the Quick Exit feature has

been enabled on your system.