DSC PowerSeries PC1616 Kurulum Kılavuzu - Sayfa 17

Güvenlik Sistemi DSC PowerSeries PC1616 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DSC PowerSeries PC1616 20 sayfaları. System enhancement module
Ayrıca DSC PowerSeries PC1616 için: Kurulum Kılavuzu (17 sayfalar), Kurulum Kılavuzu (13 sayfalar), Hızlı Kılavuz (4 sayfalar), Manuel (18 sayfalar)

Sayfayı Yazdır

Is the SEM compatible with DLS?

The SEM cannot be used as a DLS communicator. DLS panel programming

changes via another communication pathway (PC Link, POTS, etc.) will not

be captured by the SEM until the system is power cycled.

Do I need to change any programming settings for the SEM to work?

No, there aren't any required settings that need to be changed.

However, we do recommend changing the following settings if the

system was previously communicating over the phone line.

•

Disable Telco Line Monitoring (section 15, option 7)

•

Remove the phone numbers (section 301-303)

Does the SEM support reporting multiple alarms on a single zone

(swinger shutdown)?

The SEM will only report one instance of each alarm per alarm event

regardless of the settings specified on the panel. The SEM does not

support reporting multiple alarms on a single zone.

Can I can add and delete sensors remotely?

Yes, sensors can be added, changed, or deleted using MobileTech

or AirFX on the Dealer Website.

TROUBLESHOOTING

The Equipment List is empty on the Dealer Website or MobileTech

If the Equipment List is not showing on the Dealer Website or MobileTech

and the SEM failed to do a zone scan when initially powered on, verify that:

•

All wiring is correct

•

The Installer Code is synced (if the Installer Code is out of

sync you can change it to a new, unique code locally at the panel)

•

The panel is disarmed, and Request an Equipment List on the

Dealer Website or power cycle the panel

None of the LEDs on the SEM are ON

Remove power from the panel and verify that all wiring is correct.

My keypad will occasionally display "System Unavailable"

The keypad may display "System Unavailable" for brief moments while

interacting with the SEM. This is normal and expected behavior.