DSC SEA-B-QUE Kullanıcı Kılavuzu

Güvenlik Sistemi DSC SEA-B-QUE için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DSC SEA-B-QUE 4 sayfaları. 5.8 ghz wireless av/alarm kit

* Panel View:

○

1. DC+12V IN: Power input DC+12V/1.5A.

2. DC+12V OUT: DC+12V/750mA for camera only, and with an over current protector.

(Note: If you don't use this port for cameras, you can use the DC+12V/500mA adaptor.)

3. ALARM IN: Once triggered, the built-in buzzer rings on for a 20-sec time. This port could be connected to

alarm sensor, e.g.: PIR Detector, Magnetic Reed Switch Detector.

4. AUDIO IN: RCA female for input audio signal.

5. VIDEO IN: BNC female for input video signal.

6. POWER/State LED: Indicated to power on and ARM status.

7. DISARM: Alarm ON / OFF selection.

8. CH SELECT (A B C D): 5.8GHz transmission channel selection.

9. ID AND ALARM MUTE: ID address setting is use for paring with receivers (RX unit). It must be make the

same code setting to link transmitter and receiver each other. The alarm mute function is use for muting built

-in buzzer at TX

10. ANT: RP-SMA connector for connected to 5.8 GHz antenna.

REMARK: When the frequency channels have the interference, adjust antenna or change the channel of transmitter

and don't close to 802.11 a/b/g AP router and other 5.8GHz devices. (Note: Please keep 3 ~ 5 meter away)

11/5/2009

MODEL: DSC- 5800VHK(

TX unit

○

Indications

Power On

ARM

Bit 1

Bit 2

Bit 3

(Pairing with RX)

(1 = SW ON, 0 = SW OFF)

:SK2-5800A)

○

Power/State LED

High speed Flashing

ID Address

Bit 4

○

unit.

Alarm Mute

OFF