Anslut 006149 Kullanım Talimatları Kılavuzu - Sayfa 10
Aydınlatma Ekipmanları Anslut 006149 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Anslut 006149 11 sayfaları. Bulkhead light
Sayfayı Yazdır
EN
SAFETY INSTRUCTIONS
•
Designed for indoor and outdoor use.
•
Disconnect the power supply before
installation.
•
Check that the rated voltage corresponds
to the mains supply voltage.
•
Do not connect the light to the mains
while it is still in the pack.
•
Check that all electrical cables comply
with the applicable regulations and that
they are connected in accordance with the
instructions. Never attempt to replace
damaged electrical cables yourself.
•
Pay attention so that no concealed wires
are damaged in connection with
installation.
•
Be careful not to damage the insulation
on the wires during installation. Make sure
that the wires do not come into contact
with sharp edges. Damaged insulation can
result in a risk of electric shock.
•
Do not insert or remove the light source
when the light is connected to the mains.
•
Check that the bulb holder has a light
source.
•
Do not use the light without the glass. If
the glass is damaged, disconnect from the
mains before replacing the glass.
ADVARSEL!
New installations and extensions to existing
systems must always be carried out by
an authorised technician. If you have the
necessary experience (otherwise contact an
electrician), you can replace switches and
power points, fit plugs, extension cords and
sockets. Incorrect installation can result in
fatal injury and the risk of fire.
10
SYMBOLS
Approved as per applicable
directives.
Recycle discarded product
as electrical waste.
TECHNICAL DATA
Rated voltage
Output
Socket
Protection rating
For light sources with energy class
DESCRIPTION
1.
Screw
2.
Grille
3.
Glass cover
4.
Rubber seal
5.
Bulb socket
6.
Base plate
7.
Plug
FIG. 1
INSTALLATION
IMPORTANT:
Make sure the mains supply is disconnected.
1.
Mark where the light is to be mounted.
2.
Drill holes for the retaining screws.
3.
Insert the power cord through the
grommet in the light.
4.
Fasten the base plate to the wall with the
screws. Use plugs if necessary.
230 V ~ 50 Hz
Max 60 W
E27
IP44
A++ to D