DSC PowerSeries Kullanıcı Kılavuzu - Sayfa 5

Kontrol Ünitesi DSC PowerSeries için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DSC PowerSeries 20 sayfaları. Telephone interface & automation control module
Ayrıca DSC PowerSeries için: Ürün Özet Sayfası (20 sayfalar)

Sayfayı Yazdır

About Your Security System

Your Security System has been designed to provide you with the greatest possible flexibility and con-

venience. Read this manual carefully and have your installer instruct you on your system's operation

and on which features have been implemented in your system. All users of this system should be

equally instructed in its use. Fill out the "System Information" page with all of your zone information

and access codes and store this manual in a safe place for future reference.

NOTE: Please consult your installer for further information regarding the false alarm reduction

features built into your system as all are not covered in this manual.

Fire Detection

This equipment is capable of monitoring fire detection devices such as smoke detectors and provid-

ing a warning if a fire condition is detected. Good fire detection depends on having adequate num-

ber of detectors placed in appropriate locations. This equipment should be installed in accordance

with NFPA 72 (N.F.P.A., Battery march Park, Quince MA 02269). Carefully review the Family Escape

Planning guidelines in this manual.

NOTE: Your installer must enable the fire detection portion of this equipment before it becomes

functional.

Testing

To ensure that your system continues to function as intended, you must test your system weekly.

Please refer to the "Testing your System" section in this manual. If your system does not function

properly, call your installing company for service.

Monitoring

This system is capable of transmitting alarms, troubles & emergency information to a central station. If you

initiate an alarm by mistake, immediately call the central station to prevent an unnecessary response.

NOTE: The monitoring function must be enabled by the installer before it becomes functional.

NOTE: This system has a communicator delay of 30 seconds. It can be removed, or it can be

increased up to 45 seconds by the installer.

NOTE: Ensure that your Installer verifies that your system is compatible with the Central Station

Receiver format at yearly intervals.

Maintenance

With normal use, the system requires minimum maintenance. Note the following points:

• Do not wash the security equipment with a wet cloth. Light dusting with a slightly moistened cloth

should remove normal accumulations of dust.

• Replace the standby batteries every 4-5 years.

• For other system devices such as smoke detectors, motion detectors, glassbreak detectors or door/

window contacts, consult the manufacturer's literature for testing and maintenance instructions if

applicable.

General System Operation

Your security system comprises an integrated alarm control/keypad and various sensors and detec-

tors. The system is mounted by the main exit/entry location. The system is self-contained; electronics

and standby battery are housed within the keypad unit.

NOTE: Only the installer or service professional should have access to the system.

The security system has several zones of area protection. Each of these zones communicates to a sin-

gle wireless sensor (motion detectors, glassbreak detectors, door contacts, etc.) or to one or more

hard wired sensors. A sensor in alarm is indicated by messages on the LCD keypad.

Additional features include: Automatic Inhibit (Swinger Shutdown) for Alarm; Tamper and Trouble

signals after 3 occurrences in a given set period; and a Programmable Keypad Lockout option.

NOTE: For SIA CP-01 classified installations, the swinger shutdown feature is programmed such

that one or two trips will shut down the zone. The zone will be restored after a manual reset (by

entering the access code at the time of disarming the alarm system) or it will be reset automatically

after 48 hrs with no trips on any zones.