DSC WS8916 series Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 3
Duman Alarmı DSC WS8916 series için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. DSC WS8916 series 17 sayfaları. Wireless smoke detector
Sayfayı Yazdır
Owners Instructions
Fire Safety In The Home
Most fires occur in the home, and to minimize this danger, it is
recommended that a household fire safety audit be conducted and a
family escape plan be developed.
Household Fire Safety Audit
1. Are all electrical appliances and outlets in safe condition?
Check for frayed cords, overloaded lighting circuits, etc. If you
are uncertain about the condition of your electrical appliances
or household service, have a professional evaluation.
2. Are all flammable liquids safely stored in closed containers,
and in a cool and well ventilated area? Cleaning the unit
with flammable liquids should be avoided.
3. Are hazardous materials (i.e. matches) out of the reach of
children?
4. Are furnaces and wood burning appliances properly
installed, clean, and in good working order? If in doubt,
have a professional evaluation.
Family Escape Planning
There is often very little time between the detection of a fire and the
time it becomes deadly. Because of this, it is very important that a
family escape plan be developed and rehearsed.
• Every family member should participate in the escape plan.
• Study the possible escape routes from each location within the
house. Since many fires occur at night, special attention should be
given to the escape routes from sleeping quarters.
• It is essential that escape from a bedroom be possible without
opening the interior door. Consider the following when making
your escape plans:
• Ensure that doors and windows that open to the outside are easily
opened. Ensure that they are not painted shut and that the locking
mechanisms operate smoothly.
• If opening or using the exit is too difficult for children, the elderly
or handicapped, plans for their rescue should be developed. This
plan includes making sure that those who are to perform the res-
cue can promptly hear the fire warning signal.
• If the exit is above the ground level, an approved fire ladder or rope
should be provided, as well as training in its use.
• Exits on the ground level should be kept clear. Be sure to remove
snow from exterior patio doors in the winter and that outdoor fur-
niture or equipment does not block exits.
• The family should have a predetermined assembly point where
everyone can be accounted for; for example, across the street or at
a neighbor's house.
• Once everyone is out of the house, call the Fire Department.
• A good plan emphasizes a quick escape. Do not investigate first or
attempt to fight the fire, and do not attempt to rescue belongings
or valuables as this takes up time. Once outside, do not re-enter
the house; wait for the Fire Department.
• Write the plan down and rehearse it frequently so that should an
emergency ever arise, everyone will know what to do. Revise the
plan as conditions change; for example, when there are more or
fewer family members in the home or if there are changes to the
house.
• Make sure your fire warning system is operational by conducting
weekly tests. If you are unsure about system operation, contact
your smoke detector installer or dealer.
• DSC recommends that you contact your local Fire Department and
request further information on home fire safety and escape plan-
ning. If available, have your local fire prevention officer conduct an
in-house fire safety inspection.
Testing Your Smoke Detector
Follow the test procedure described here or contact your
smoke detector dealer or installer for testing instructions. DSC
recommends that you test the entire alarm system at least
once a week to verify the operation of all system functions.
Smoke Detector Unit Test
Initiate test by pressing the test button for 5 seconds (min.), the siren
makes clicking noises during this time. Press the button until the unit
alarm sounds, an alarm should be sent to the control panel. When
the button is released, the alarm should cease. If this does not occur,
ensure batteries are the correct type, in good condition and are
installed correctly (see 3. Install Batteries in the Installation
Instructions section).
Upon completing the functional testing of the smoke detector, check
the unit's sensing chamber to ensure proper operation. To test the
sensing chamber, wave a lit cotton wick or punk stick around the
outside of the unit until a generous amount of smoke enters the
sensing chamber or the unit alarms. If the smoke detector does not
function properly, call your smoke detector installer or dealer for
service.
Owners Maintenance
The smoke detector is designed to require minimum maintenance. If
the case becomes dusty, vacuum with a small brush attachment. If
the case is greasy, wipe the case gently with a soft cloth slightly
dampened with soapy water.
Never disassemble the smoke detector; there are no user ser-
viceable parts inside the unit. You may only remove detector
from backplate to replace batteries if not serviced by installer.
When replacing the batteries, follow the instructions specified
within the Installation Instructions, Item 3 Install Batteries.
CAUTION: This product uses lithium batteries, improper han-
dling may result in a HEAT, EXPLOSION or FIRE causing per-
sonal injury. DO NOT recharge batteries. Follow the battery
manufacturer's safety instructions. Dispose of used batteries
in accordance with the regulations in your area.
Never paint the unit. Paint may prevent smoke from entering
the unit. If you are planning renovations or repainting, con-
tact your installer and ask that the unit be temporarily
removed until work is complete.
If the unit is located in an area where it is exposed to high levels of
dust or insects and causes false alarms, it may require service;
contact your smoke detector installer or dealer.
Specifications
• Diameter (base): 5.8in (147 mm)
• Height (including base): 2.077in (528 mm)
• Alarm Sensitivity (threshold): complies with EN54-7
• Warning threshold: 75% of alarm threshold for 120 seconds
• Heat Alarm: 57ºC (135ºF)
• Supervisory Transmission Frequency: 12 minute intervals
• Siren Alarm Pattern: evacuation temporal pattern
• Operating Temperature with Heat Detector:
5º-38ºC (41º-100ºF)
• Humidity: 5%-95% RH, non-condensing
• Batteries (2) CR123A
• Low Battery Detection Low battery 14 days remaining
• Approved Batteries: Panasonic CR123A, Sanyo CR123A and Duracell
DL123A
Alarm Indications
Condition
LED
Normal
Flash 1/50s
Alarm Smoke
Flash 1/1s
Alarm Heat
Flash 1/1s
Early Warning
Flash 1/50s
Smoke
Compensation
OFF
Trouble High
Compensation
OFF
Trouble Low
Sensor/
OFF
Internal Fault
Low Battery
Flash 1/50s
0 - 7 days
Low Battery
Flash 1/50s
0 - 7 days & Test or
Alarm
Low Battery After
Flash 1/50s
7 days
Tamper
Flash 1/50s
The smoke alarm WS8916 has a recommended service life of 10
years under normal conditions of use. Please refer to the label
applied to the device indicating the recommended replacement year.
For servicing the unit or replacement batteries please call your installation
company that provided you with the alarm system.
Siren
Transmission
OFF
Supervisory
Temporal
Alarm
or Steady
Temporal
Alarm
or Steady
CHIRP
None
CHIRP
Trouble
CHIRP
Trouble
CHIRP
Trouble
OFF
Low Battery
Low Battery
CHIRP
Low Battery
CHIRP
OFF
Tamper