3M Purification AP101 Talimatlar Kılavuzu - Sayfa 2

Su Filtrasyon Sistemleri 3M Purification AP101 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. 3M Purification AP101 12 sayfaları. Valve-in-head, seals replacement kit, style/style heads

Sayfayı Yazdır

To reduce the risk associated with property damage due to water leakage:

• Read and follow Use Instructions before installation and use of this system.

• Installation and use MUST comply with all state and local plumbing codes.

• Protect from freezing, remove ﬁ lter cartridge when temperatures are expected to drop below 33° F (0.6° C).

• Do not install systems in areas where ambient temperatures may go above 110°F (43.3°C).

• Do not install on hot water supply lines. The maximum operating water temperature of this ﬁ lter system is 100°F (37.8°C).

• Do not install if water pressure exceeds 125 psi (862 kPa). If your water pressure exceeds 80 psi (552 kPa), you must install a pres-

sure limiting valve. Contact a plumbing professional if you are uncertain how to check your water pressure.

• Do not install where water hammer conditions may occur. If water hammer conditions exist you must install a water hammer ar-

rester. Contact a plumbing professional if you are uncertain how to check for this condition.

• Where a backﬂ ow prevention device is installed on a water system, a device for controlling pressure due to thermal expansion must

be installed.

• Do not use a torch or other high temperature sources near system, cartridges, plastic ﬁ ttings or plastic plumbing.

• On plastic ﬁ ttings, never use pipe sealant or pipe dope. Use PTFE thread tape only, pipe dope properties may deteriorate plastic.

• Take care when using pliers or pipe wrenches to tighten plastic ﬁ ttings, as damage may occur if over tightening occurs.

• Do not install in direct sunlight or outdoors.

• Do not install near water pipes which will be in path of a drilling tool when selecting the position to mount the bracket.

• Mount system in such a position as to prevent it from being struck by other items used in the area of installation.

• Ensure that the location and fasteners will support the weight of the system when installed and full of water.

• Ensure all tubing and ﬁ ttings are secure and free of leaks.

• SHUT OFF FUEL OR ELECTRIC POWER SUPPLY TO WATER HEATER after water is shut off.

Item

Description

Seal Rings

Large Shaft O-Ring

Small Shaft O-Ring

Vent O-Ring

Spool O-Ring

Filter Handle

Valve Screw

Valve Assembly

CAUTION

large washer

small

washer

pronged

spool

small

washer

Valve Assembly (Item 8) Exploded View

Figure 1

valve

o-ring

spacer

internal

tooth lock

washer