3M-Matic S867 L-Clip Applicator Talimatlar ve Parça Listesi - Sayfa 2

Gıda Tasarrufu 3M-Matic S867 L-Clip Applicator için çevrimiçi göz atın veya pdf Talimatlar ve Parça Listesi indirin. 3M-Matic S867 L-Clip Applicator 6 sayfaları. 10500;29500

Sayfayı Yazdır

Installation

WARNING

•

To reduce the risk associated with

mechanical hazards:

−

Turn air supply off and disconnect before

performing any adjustments, maintenance, or

servicing the machine or taping heads.

•

To reduce the risk associated with sharp

blade hazards:

−

Keep hands and fingers away from tape cutoff

blades under orange blade guards. The

blades are extremely sharp.

1. Pull buffing assembly up through front of machine

and replace existing upper buffing sleeves with

the new larger diameter upper buffing sleeve

supplied with this kit. See Figure 1.

Important: Be sure to replace the sleeve on the

UPPER buffing arm, NOT on the lower buffing

arm.

2. The S867/S857 "U" Clip Modification Kit requires

four tapped holes in the top surface of the L-clip

applicator. Some older S857 applicators do not

have these holes. If not, the holes must be

located, drilled, and tapped. Use the enclosed

hole template and follow Steps A–E on the

template. If your machine already has these

holes, skip this step.

3. Attach mounting bracket to the front edge of the

L-clip applicator with two 10-24 x 1/2 capscrews

and plain washers as shown in Figure 2.

4. Remove the T-fitting from end of poly tubing on

modification kit. Push end of fitting in to release

tubing. See Figure 2.

5. Unlatch and open right side cover on the L-clip

applicator. Feed poly tubing through hole in left

side of applicator (Figure 3A) and route behind

existing tubing towards back of applicator (Figure

3B).

Note: Be sure tubing does not interfere with any

moving parts of applicator. The 32.5" tube must

be cut to 13.5" length if installed on a S857.

Figure 1—Replace Buffing Sleeves

Figure 2—Attach Mounting Bracket

Figure 3—Install Poly Tubing