DSE UNIVERSAL Hızlı Kullanım Kılavuzu

Verici DSE UNIVERSAL için çevrimiçi göz atın veya pdf Hızlı Kullanım Kılavuzu indirin. DSE UNIVERSAL 2 sayfaları.

UNIVERSAL
QUICK USER GUIDE
NOTE : Please refer to the ICONS on your transmitter to the following instructions
Lock / Arm
(optional)
Press button to Lock/*Arm. Parking lights will flash once, horn or siren chirp once (if installed).
*System is armed within 6 seconds. LED ( flashing light on antenna) starts flashing. Any attempt
to open the doors will immediately trigger the horn for 30 sec. (or siren for 60 sec.) To stop,
press the same button again once, Panic – (Also see section Panic below) Hold for 1.5sec will
LOCK
ARM
trigger the horn or siren to sound continously. To stop, press and release momentarily
Unlock / Disarm
(optional)
Press button to Unlock/*Disarm. Parking lights flash twice with 2 chirps. System is disarmed.
Starter kill function is temporarily suspended for 60 seconds
Trunk
(optional)
UNLOCK
Hold button for 2 seconds to release the trunk. Parking lights will flash 3 times
DISARM
Silent mode
(optional)
Press momentarily to Lock/*Arm or Unlock/*Disarm SILENTLY ( without chirp )
OPTION
Start / Stop
Press to start. Parking lights will flash 6 times and stay on for the duration of the cycle
START
( 20 or 3 minutes ). Press again to stop
STOP
Panic
1. Hold for 1.5sec will trigger the horn or siren to sound continuously
2. To stop, press and release momentarily
RED
*If the remote does not have this icon, see section Lock (Panic) above
Mis-touch Function
(For specific model only)
To lock all the buttons:
1-Press both
+
(LOCK + START) (FM2W)
2-To reactivate the function, repeat the same procedure as in 1
TURBO mode
1-Press both buttons
+
(START + SILENT) momentarily, park lights will flash 3 times.
2-Remove the key, open and close door. Engine will shut off after 2 minutes
LED
(flashing light located on antenna – optional)
1-The LED lights up when you first start the engine then goes out when the brake pedal is depressed
If it is not the case, contact your installer
2-When the alarm and the starter kill are active, the LED will flash once every one second
Cold Start Timer
(every 2, 3 or 4 hrs for 6/10/15/20 minutes when installed)
1- Press
+
(LOCK + UNLOCK) buttons at the same time to enable this function, parking lights
will flash 2 times to confirm for 2 hrs
2- Repeat same for 3 hrs and for 4 hrs
3-To Cancel this feature, start the vehicle with the transmitter or with the key
Important: Do not use this feature when the vehicle is parked in a closed area
Security switch On/Off
(locate inside the vehicle )
1-Leave the Security Switch ( ON/OFF switch) to the OFF position to disable the operation of the
remote starter (such as when indoor parking or at car maintenance, etc...)
2-Switch back to ON position for normal operation
OFF= No remote start ON= Yes remote start
OFF
ON
V05 April 2011
D
S E
www.dsecanada.com