3nStar LDT104 Hızlı Kurulum Kılavuzu

Etiket makinesi 3nStar LDT104 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. 3nStar LDT104 2 sayfaları.

Sayfayı Yazdır

Quick Installation Guide

Printer overview

LED indicator

Feed button

Top cover open lever

Note:

The interface picture in the quick start guide is for reference only. Please

refer to the product specification for the interfaces availability.

Printer Installation

1.Arrange this printer on a reliable flat surface and make sure the power switch is off.

2.Connect the printer to a computer mainframe with a provided Centronics,RS-232 or

USB cable.

3.Plug the power cord into the power jack

connector at the rear of the printer, then plug

the power cord into a properly grounded outlet.

Power jack

Note:

Please switch OFF printer power switch prior to

plug in the power cord to printer power jack.

Loading the label

1.Insert a 1" label spindle into a paper roll (* If your paper core is 1''inch, remove

the 1.5'' core adapter from the fixed tab).

1.5'' Core Adaptor

Printing side face up

Rear paper guide

Ethernet interface

power switch

MicroSD slot

Power jack

USB interface

RS-232

Paper Roll

Fix Tab

1"label spindle

2.Open the printer top cover by pushing

forward the top cover open levers.

3.Orient a roll of paper on the paper roll mount.

4.Feed the paper, printing side face up, through

the label guide and pass over the platen.

5.Adjust the black center-biasde label guides in

or out turning adjustment knob so they are

slightly touch the edges of the label backing.

6.Close the printer top cover slowly and make sure

Power supply

the cover locks latch securely.

Power plug

7.Use the "Diagnostic tool" to set the media sensor type

and calibrate the selected sensor. (See "Diagnostic

tool" and "Sensor Calibrate" in the next page).

Note:

1. Please calibrate the gap/black mark sensor when changing media.

2. Failure to securely close and lock the cover will result in

poor print quality.

Button functions

(1)Feed labels

When the printer is ready, press the button to feed one label to the beginning of next label.

(2)Pause the printing job

When the printer is printing, press the button to pause a print job. When the printer is

paused the LED will blink green. Press the button again to continue the printing job.

Top cover open lever

Label guide

Printer top cover

Paper roll mount

Adjustment knob