3One data IES2010-2GS-4F Donanım Kurulum Kılavuzu - Sayfa 4

Ağ Yönlendiricisi 3One data IES2010-2GS-4F için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. 3One data IES2010-2GS-4F 5 sayfaları. Unmanaged industrial ethernet switch

Sayfayı Yazdır

【Installation】

Before installation, confirm that the work environment meet the installation require, including the power needs and abundant space. Whether it is close

to the connection equipment and other equipments are prepared or not.

1. Avoid in the sunshine, keep away from the heat fountainhead or the area where in intense EMI.

2. Examine the cables and plugs that installation requirements.

3. Examine whether the cables be seemly or not (less than 100m) according to reasonable scheme.

4. Screw, nut, tool provide by yourself.

5.Power need: 24VDC power inputs(12~48DC）

6. Environment: -25°C to 70°C

Relative humidity 10% to 95%

DIN Rail Installation

In order to use in industrial environments expediently, IES2010-2GS-4F series adopt 35mm DIN-Rail installation, the installation steps as below,

1. Examine the DIN-Rail attachment

2. Examine DIN Rail whether be firm and the position be suitability or not.

3. Insert the top of the DIN-Rail into the slot just below the stiff metal spring.

4. The DIN-Rail attachment unit will snap into place.

Wiring Requirements

Cable laying need to meet the following requirements,

1. It is needed to check whether the type, quantity and specification of cable match the requirement before cable laying;

2. It is needed to check the cable is damaged or not, factory records and quality assurance booklet before cable laying;

3. The required cable specification, quantity, direction and laying position need to match construction requirements, and cable length depends on

actual position;

4. All the cable cannot have break-down and terminal in the middle;

5. Cables should be straight in the hallways and turning;

6. Cable should be straight in the groove, and cannot beyond the groove in case of holding back the inlet and outlet holes. Cables should be

banded and fixed when they are out of the groove;

7. User cable should be separated from the power lines. Cables, power lines and grounding lines cannot be overlapped and mixed when they are in

the same groove road. When cable is too long, it cannot hold down other cable, but structure in the middle of alignment rack;

8. Pigtail cannot be tied and swerved as less as possible. Swerving radius cannot be too small (small swerving causes terrible loss of link). Its

banding should be moderate, not too tight, and should be separated from other cables;

9. It should have corresponding simple signal at both sides of the cable for maintaining.

【Specification】

Technology

Standard：IEEE802.3、IEEE802.3u、IEEE802.3x、IEEE802.3z

Transmit Rate：148810pps

Max Rate of Filtrate：148810pps

Processing type: Store and Forward

MAC address：8K

Interface

RJ45 port：10/100BaseT(X) auto connection, Full /Half duplex or force work mode, and support MDI/MDI-X connection

Fiber port：100BaseFX ports (SC/ST connector, optional)

Single-mode: 20, 40,60, 80, 100,120Km,optional

Multi-mode: 2Km, optional. 1000BaseSX/LX/LHX/ZX（LC connector）

Wavelength: 850nm, 1310 nm, 1550nm

Power

24VDC power input（12～48VDC）

Consumption is less than 8.1W

Overload Current Protection