3One data IES205 Donanım Kurulum Kılavuzu - Sayfa 6

Anahtar 3One data IES205 için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. 3One data IES205 9 sayfaları.

below.

Wiring

Requirements

Wiring

Wiring Requirements

Requirements：

Be sure to disconnect the power cord before installing and/or wiring

your Ethernet Switch.

Calculate the maximum possible current in each power wire and

common wire. Observe all electrical codes dictating the maximum

current allowable for each wire size. If the current goes above the

maximum ratings, the wiring could overheat may causing serious

damage to your equipment. You should also pay attention to the

following items:

1. Use separate path to route wiring for power and devices. If power

wiring and device wiring paths must cross, make sure the wires

are perpendicular at the intersection point.

2. NOTE: Do not run signal or communications wiring and power

wiring in the same wire conduit. To avoid interference, wires

with different signal characteristics should be routed separately.

3. You can use the type of signal transmitted through a wire to

determine which wires should be kept separate. The rule of

thumb is that wiring that shares similar electrical characteristics

can be bundled together.

4. Keep input and output wiring separated. It is strongly advised

that you label wiring to all devices in the system when necessary.

Your Serial and Data Communications Expert

Shenzhen 3onedata Technology Co.,Ltd