Attero Tech unHX2D Kullanıcı Kılavuzu - Sayfa 15

Kayıt Ekipmanları Attero Tech unHX2D için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Attero Tech unHX2D 18 sayfaları. Dante-enabled hdmi audio de-embedder/embedder

Sayfayı Yazdır

4 – 3

Party Control

The unHX2D supports 3

party control of the device parameters.

There are two control interface types available for the unHX2D. The first type is a Dante proprietary interface which is

typically used by devices that already have built-in support for Attero Tech devices. The second type supports a 3

UDP interface and is available to anyone to use with any device capable of sending and receiving UDP messages.

Information on the commands the unHX2D supports as well as details of how to use the 3

found in the unIFY 3

party Software API document, available from the registered users section of the Attero Tech website

(Go to

www.atterotech.com

4.1 – Command Interface Type

The type of command interface a specific unHX2D supports is defined by the Dante firmware it has been loaded with.

There are two methods to determine which Dante firmware and thus which command interface that is:

Run unIFY Control Panel V2.3 or later. Right-click on the device, and select the "Device Info" option. The interface

type is shown indicated by the "Control Type" field. A "-C" means the device is using the Dante Proprietary

interface. A "-U" means the device is using the 3

Using Dante Controller, double-click on the device in question, select the "Status" tab and look for the "Firmware

Version" parameter in the "Device Information" box. If the Firmware Version is V1.x.x, the device is using the

Dante Proprietary interface. If it is V2.0.0, the device is using the 3

A device's command interface can be changed simply by updating the device's Dante firmware. Moreover, this can be

done in the field in almost all cases. The tools and necessary firmware files for updating a device's command interface

can be obtained from the registered users section of the Attero Tech website (Go to

log-in option). The firmware files have an extension .DNT (otherwise known as "donut" files) and there is one for each

command interface type. The file with the –C in its name supports the Dante proprietary interface while the one with "-U"

in its name supports the 3

4.2 – Using the Command interface

In order to make use of the command interface, regardless of type, the unHX2D simply needs to be configured with an IP

address that is compatible with the device doing the controlling. The control devices should then be able to converse with

the unHX2D without any further configuration necessary.

 Attero Tech LLC 2018

and click on the log-in option).

Party UDP interface.

party UDP interface.

party UDP control interface.

Page 15

unHX2D

User Manual

party UDP interface can be

www.atterotech.com

and click on the

614-00038 Rev 01_a

party