DT DT SCREENS Dynamic 2S Kurulum Kılavuzu - Sayfa 5

Projektör Aksesuarları DT DT SCREENS Dynamic 2S için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DT DT SCREENS Dynamic 2S 12 sayfaları.

Installation

•

Decide on the height you want the bottom of the visible projected image to be at on your

finished screen. Mark this height on the wall where you are installing the screen. Now add

28mm to this further up the wall. This will be the height at which the top of the back plate

on the bottom screen sections will sit.

Now mark the central left to right point for the screen (normally the centre line of the

•

room.) This will be the centre of the Bottom screen sections.

Take the bottom right section of the screen frame (the one with the control box in it). Line

•

this up so that the tip of the back plate is level with your pre marked height line on the wall

and the left end of it is lined up with the centre mark.

•

Screw the frame section to the wall using the holes at the top of the back plate. Use a spirit

level to ensure that this section is level. This is very important as it will form the basis for

the rest of the screen to be built to.

•

Prepare the bottom left section to be fitted. There are two joining sliders which join the

bottom sections together.

•

Now lift the bottom left section and mate the joining slider into the respective profile until

the two ends of the profile meet fully. These can be secured in place using the grub screws

in the joining bars. Screw this section to the wall again using the holes in the top of the back

plate.

Next take the left screen section and align the joining sliders into their retrospective

•

aluminium profile son the bottom left screen section. Slide these the left section in until the

ends of the aluminium profile meet. (You may also need to help guide the white mask slider

into the groove on the aluminium profile)

Screw the left section to the wall again using the holes in the top of the back plate.

•

Tighten the grub screws in the joining bars between the Left and the bottom left screen

sections.

Using a spirit level check the Left screen section is vertical and adjust if nessasery.

•

Dynamic 2S Installation Manual – V0.2