DTC PB-5 Operatör El Kitabı - Sayfa 9

Verici DTC PB-5 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. DTC PB-5 16 sayfaları. Beacon transmitter

Sayfayı Yazdır
1
Connect an antenna to the RF Output connector on the transmitter.
2
Connect the break wire and or standby wire depending on the desired configuration.
3
Using the supplied screwdriver, turn the channel selector to the correct channel number.
4
Connect the power source to the PB-5's power terminals.
5
If standby wire is used the PB-5 will not be enabled until the wire is removed. You will have to remove the wire to
activate.
6
If standby wire is not used, the PB-5 is activated immediately, and will operate within the programmed parameters.
7
If the default settings are not the desired settings, then programming is required. Go to the programming section on
page 12 to program the PB-5 with new settings.
Warning: Do not exceed 7.5 Volts
POWER
4
BREAKWIRE
STANDBY
WIRE
5
LED
2
3
CHANNEL/
MODE SWITCH
Warning: Do not apply power to the transmitter
until an antenna has been connected in step 1.
INIT PUSH-BUTTON
TEST PUSH-BUTTON
QUICK START
1
ANTENNA
PROGRAMMING
CABLE
DTC COMMUNICATIONS, INC.
9