DTD CUB 15 Kullanıcı El Kitabı - Sayfa 12

Dalış Aleti DTD CUB 15 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. DTD CUB 15 18 sayfaları. Buoyancy compensator
Ayrıca DTD CUB 15 için: Manuel (6 sayfalar)

Sayfayı Yazdır

1. Wings

TUNING THE COMPENSATOR

Assembly of the compensator for using with single bottle

We recommend first bolting the wing and the backplate loosely together. Run

the bolt through the wing and then the backplate in such a way that the nut

faces your back and the bolt head shows up on the wing. Do not tighten the bolt

yet; the wing should be loose enough on the backplate to facilitate the

assembly. Attach the wing in such a way that the logo can be seen while looking

at the backplate; that is, the corrugated hose knee-joint is on the opposite side

from the backplate.

Attaching the inflator: detailed description in „2. Assembly of the compensator

for use with doubles".

How to thread the bottle straps

Pass the straps with the buckle designed to hold the cylinder through a strap

slot in the wing (1). The Velcro on the strap must be turned to the outside, in

the direction of the wing's perimeter. Continue by threading the strap through a

corresponding horizontal slot in the backplate (2), and then through a slot on

the other side of the backplate´s bending (3). Then thread the strap through a

strap slot in the wing (4, 5). Move the strap so that the Velcro near the buckle

runs through both strap slots of the wing. Leave about 10 cm of the strap close

to the buckle without threading it through the wing. Follow the same procedure

for the second strap.

pic. 1

pic. 4

Revised – February 2020

pic. 2

pic. 5

pic. 3

pic. 6