Attonic AD-TM50 Kullanım Kılavuzu - Sayfa 12

Ölçüm Cihazları Attonic AD-TM50 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Attonic AD-TM50 20 sayfaları.

Attonic AD-TM50 Kullanım Kılavuzu
7-7.Set flipping screen DP (Initial Setting: OFF)
・It is a setting to flip the screen.
For example, when measuring with the detection shaft facing up, the values are displayed upside-down and
difficult to read, but by turning on this setting, the values can be read as they are.
* You can switch ON / OFF repeatedly by pressing the "DAT" switch.
* Short press the "FUN" switch to confirm the setting. Next is the setting for auto power off.
7-8.Set auto power off  AF (Initial Setting: ON)
・It is a setting to turn off the power if no operation is performed for 10 minutes.
  Turn this setting OFF if you want to use the meter for a long time.
  The measurement will remain until the battery runs out.
* You can switch ON / OFF repeatedly by pressing the "DAT" switch.
* Short press the "FUN" switch to confirm the setting. Next is the setting for auto reset.
7-9.Set auto reset  AC  (Initial Setting : OFF)
・ It is a setting to automatically reset after 3 seconds when the load torque disappears.
You don't have to press the reset button every time you run the same test over and over again.
* When reset, the data will be saved automatically.
* Work efficiency will increase when used in combination with printer output.
* You can switch ON / OFF repeatedly by pressing the "DAT" switch.
* Short press the "FUN" switch to confirm the setting. Next is the setting for the minimum digit display.
7-10.Set the minimum digit display MD (Initial Setting: ON)
・Set whether to display the minimum digit or not.
The display looks more stable when the minimum digit is not displayed (OFF).
* The display range varies depending on the model. For the display range, refer to the display range table.
* You can switch ON / OFF repeatedly by pressing the "DAT" switch.
* Short press the "FUN" switch to confirm the setting. Next is the setting for buzzer.
The display changes every
time the "DAT" switch is
pressed.
The display changes every
time the "DAT" switch is
pressed.
The display changes every
time the "DAT" switch is
pressed.
The display changes every
time the "DAT" switch is
pressed.