Attwood 3800 Series Kurulum Talimatları - Sayfa 2

Deniz Aydınlatma Attwood 3800 Series için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Attwood 3800 Series 2 sayfaları. 3800 series stainless steel 2-mile sidelights, bicolor combination bow light, sidelight pair

Sayfayı Yazdır

1. Connect one lead to the negative (-) post of the 12-volt supply.

Connect the other lead to a fused and switched positive (+) 12-volt

supply. Sidelights require 1-amp fusing per lamp: a 1-amp fuse

for the Bicolor Combination light, a 2-amp fuse for the Sidelight

Pair. Note that navigation rules require sidelights to be operated

separately from anchor lights. Use either two switches or a single

switch with three positions for off/anchor/running (See Figure 3).

Figure 3

2-Amp Fuse

2. Check gasket to be sure the hole lip is down. Feed wires and

connectors down through the gasket (See Figure 4).

3. Be sure base is seated into the gasket ring all the way around

(See Figure 4 Detail).

4. Align base so the hole lip fits down into the wire clearance hole.

Insert two #10 stainless steel mounting screws and fasten them

to the deck. Note: Do not fasten screws so tightly that the gasket

is deformed.

5. To replace lens: Be sure O-ring is seated on the base screw

mount. Seat lens so the base tabs fit in the lens grooves and

base screw mount lines up with the lens screw hole. Be sure

the gasket is outside the lens at the back.

Figure 4

Detail

Switch

Lens

Groove

Base Tab

O-Ring

Base

Gasket

Lens

Gasket

Hole Lip

6. Place stainless steel cover over lens. Be sure gasket is inside

the stainless steel cover at the back. Reinstall screw into cover

(See Figure 5).

Figure 5

MAINTENANCE

To replace lamp: Remove the cover screw, cover, and lens.

You may need to pry the lens from the gasket with a small flat

screwdriver, starting in the front of the light.

Remove old lamp by rotating 1/8 turn counterclockwise and pulling

forward. Replace lamp with the proper bayonet bulb (Attwood Part

Number 912717). Check position of O-ring on the base screw mount.

Carefully replace lens and cover on gasket to maintain the waterproof

seal. Reinstall cover screw.

ATTWOOD LIMITED WARRANTY

ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331

("Attwood") warrants to the original consumer purchaser that Attwood brand

products will be free from defects in materials and workmanship under normal

use and service for one year from the date of original consumer purchases.

This limited warranty is not applicable if the product has been damaged by

accident, improper installation, unreasonable or improper use, lack of proper

maintenance, unauthorized repairs or modifications, normal wear and tear,

or other causes not arising out of defects in materials or workmanship.

Attwood products are warranted for use on pleasure boats. Any other use—

including but not limited to commercial, racing, or non-marine use—are not

covered under this warranty. Attwood's obligation under this warranty is limited

to repair of the product at Attwood's plant or replacement of the products at

Attwood's option without expense to the original consumer purchaser. Any

expenses involved in the removal, reinstallation or transportation of the

product are not covered by this warranty.

The product must be returned to Attwood's plant at the address above,

postage pre-paid, and insured with proof of original purchase including date.

If Attwood is unable to replace the product and repair is not commercially

practical or cannot be timely made, or if the original consumer purchaser

is willing to accept a refund in lieu of repair or replacement, Attwood may

refund the purchase price, less an amount for depreciation. The acceptance

by Attwood of any product returned or any refund provided by Attwood shall

not be deemed an admission that the product is defective or in violation of

any warranty. Products that are replaced or for which a refund is issued

become the property of Attwood.

THIS WARRANTY IS ATTWOOD'S ONLY EXPRESSED WARRANTY OF

THESE PRODUCTS. NO IMPLIED WARRANTY INCLUDING, WITHOUT

LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND

FITNESS FOR A PARTICULAR PURPOSE, SHALL BE EXTENDED BEYOND

THE WARRANTY PERIOD STATED ABOVE FOR EACH PRODUCT.

ATTWOOD SHALL NOT BE LIABLE FOR ANY DAMAGES, FOR LOSS

OF USE OF THIS PRODUCT, NOR FOR ANY OTHER INCIDENTAL OR

CONSEQUENTIAL DAMAGES, COSTS, OR EXPENSES.

Some states do not allow limitations on how long an implied warranty lasts

or the exclusion or limitation of incidental or consequential damages, so the

above limitations and exclusions may not apply to you. This warranty gives

you specific legal rights, and you may have other rights which vary from

state to state.

Attwood

Subsidiary Steelcase Inc.

1016 N. Monroe Street, Lowell, MI 49331-0260

Lens Cover

Gasket