Attwood 69397 Kurulum Talimatları

Tekne Ekipmanları Attwood 69397 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Attwood 69397 1 sayfaları. Bilge and aerator pump replacement motor cartridge

Sayfayı Yazdır
3
Bilge and Aerator Pump
Replacement Motor Cartridge
4620, 4622, 4624, 4623, 4625 Series
SAVE THESE INSTRUCTIONS
Form Number 69397 Rev. A
WARNING
Read all instructions carefully before installing and using this product.
To prevent personal injury, disconnect the power source when installing
or servicing this product. Always remove the boat from the water before
using 120V AC power tools.
DO NOT use pump to remove gasoline, oil or other flammable liquids.
Always use the fuse amperage rating specified for your pump model.
Failure to do so could result in serious personal injury or fire hazards.
Attwood bilge pumps are designed to exhaust STANDING WATER
ONLY. They are not intended to prevent rapid accumulation of
on-board water due to rough weather, hull damage, and/or other
unsafe navigational conditions.
PRODUCT FEATURES
The Attwood Motor Cartridges are an easy solution for replacement
of an Attwood Cartridge Bilge or Aerator Pump. The Replacement
Motor Cartridges are interchangeable between same-capacity pumps
and aerator pumps. And you can replace the motor without changing
the hose or base installations.
The cartridges are color-coded to help you match cartridge size to the
pump or aerator:
12-Volt Cartridges
Product Number
500 Series
4620
800 Series
4622
1200 Series
4624
24-Volt Cartridges
Product Number
800 Series
4623
1200 Series
4625
®
COLOR
RED
BLUE
GRAY
COLOR
BLUE
GRAY
To Remove Existing Cartridge
WARNING
If Aerator is installed thru-hull, BOAT MUST BE OUT OF THE
WATER to remove or replace motor cartridge.
The pump, plumbing and connections may be below the water level.
Removing the cartridge while the boat is in the water may result in
flooding and sinking of your boat.
1. Hold pump housing firmly. Depress motor cartridge tabs, then
twist cartridge counter-clockwise to remove.
Figure 1
10-03
To Insert new motor cartridge
1. Check motor cartridge fit. Motor color must match housing color:
600 Series = RED, 800 = BLUE, 1200 = GRAY.
2. Coat O-ring with vegetable oil to ease insertion.
3. Insert cartridge into housing. Twist clockwise until you hear tabs
snap up into slot.
Figure 2
Unlock
Red Tab
"O" Ring
WARNING
To avoid leaking or sinking, the aerator RED TAB MUST BE
LOCKED AND VISIBLE through aerator housing slot.
ATTWOOD LIMITED WARRANTY
This Attwood Motor Cartridge carries a three (3) year warranty.
See product catalog or www.attwoodmarine.com for details.
©2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
Lock
Unlock
Motor
Cartridge Tab
Motor Cartridge
Lock
Red Tab
Must Be Extending Thru Slot