Atwood 493433 Kurulum Operasyon ve Bakım - Sayfa 5

Otomobil Aksesuarları Atwood 493433 için çevrimiçi göz atın veya pdf Kurulum Operasyon ve Bakım indirin. Atwood 493433 7 sayfaları. Bike rack for recreational vehicle ladder

Sayfayı Yazdır

For a pair of bikes, install the bikes on the Bike Rack

with the handlebars overlapping (see illustration below),

then install (1) 30" strap with a Superlock buckle by

placing the strap through the bike frame and around the

bike frame's fork member of both bikes (see illustration

below). Leave the strap slightly loose as it will tighten in

the following steps.

4. Install (1) 54" strap with Superlock buckle around the

rear axle support members of the outer bike and through

the rear wheel spokes. Continue to run the strap toward

the outer rail on either side of the ladder, inserting the

straps through the rear wheel spokes of the inner bike if

present. Wrap the strap around both rails of the ladder

with the buckle in the straight section of the strap behind

the ladder. Tighten strap until the bike(s) straighten up

and become parallel with the ladder. For dual bikes, this

step should tighten the previously installed strap around

the bikes forks. If not, adjust the fork strap until tight.

5. Final strap...

Tie (1) 12" Velcro strap around the handlebars of the two

bikes where they overlap. Tighten to keep the

handlebars and front wheels from swinging.

Three pieces of split round foam (provided) can be

inserted in any area where the bikes come into contact

with each other or any part of the mounting surface or

structure.

MAY CAUSE PERSONAL INJURY OR PROPERTY

Check the straps and bike position occasionally,

especially if traveling on bumpy or unpaved roads.

Adjust into correct position as necessary, ensuring all

straps are tight at all times. It is the responsibility of the

user to verify bikes are secure to rack and rack is

secure to the ladder.

CAUTION

DAMAGE