Comtrend Corporation WAP-5883 Hızlı Kurulum Kılavuzu - Sayfa 4
Genişletici Comtrend Corporation WAP-5883 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Comtrend Corporation WAP-5883 16 sayfaları. Wireless-n range extender
Sayfayı Yazdır
C. Repeater Mode Installation Guide
Repeater mode can extend your wireless signal and coverage, and will help you
solve wireless dead zone problems.
For first time setup and installation, move the extender close to the access point
you wish to connect to and, after installation is complete, move the device to the
place you wish to use it.
AP
Repeater
Client
Signal
WLAN
Power
WPS
LAN
WPS
Using the WPS button to establish a fast and secure connection without a computer:
Signal
WLAN
Power
WPS
LAN
WPS
(1) Press and hold the WPS button on the extender for 2 seconds, the 'WPS'
LED will start flashing.
(2) Press the WPS button on the access point you wish to connect to within 2
minutes. If the access point you wish to connect to does not have a hardware
WPS button, you can also use its web configuration menu's WPS function to
establish a connection. Or you can login to the WAP-5883's web UI to perform
quick setup (detailed setup is explained in the section that follows below).
( )
2
(1)
Reset/WPS
3
Switch to 'Repeater' mode.
Plug the WAP-5883 into a
power outlet on the wall, and
flip the power switch to 'ON'
(1). The 'Power' LED should
light up in a few seconds (2). If
not, check if the power outlet
you're using is working.