Aube Technologies Pilot-wire Programmer TH134 Kurulum ve Kullanım Kılavuzu - Sayfa 3
Termostat Aube Technologies Pilot-wire Programmer TH134 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Aube Technologies Pilot-wire Programmer TH134 4 sayfaları. Pilot-wire programmer
Sayfayı Yazdır
Whenever an order is received via the remote input, it becomes the
active order for all 3 zones. To know which orders can be initiated
by the energy manager, the phone controller or the home automa-
tion system, see the table on page 1. The
signals are received via the remote input.
Orders received via the remote input have priority over orders initi-
ated via the TH134 programmer. However, you can bypass the
remote input order for each zone for 2 hours. At the end of the 2
hours, the remote input order becomes active again.
Select the zone using the Zone button. (Press for 3
seconds to select all 3 zones.)
Press the desired order button.
The
icon flashes during the bypass.
The same schedule is used by default for all 3 zones as shown
below.
Wake-up time
Leave for work
Every day
Monday to
Friday
C
S
C
S
Use the following procedure to select the order and the start time for
each of the 4 programs for each zone. The settings of each pro-
gram will be the same for each day. However, you can then select
which programs to be executed for each day and for each zone.
Press the PGM to start programming.
TH134
is displayed when
Return home
Sleep time
Monday to
Every day
Friday
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
4
4
4
4
4
Select the zone using the Zone button. (Press for 3
seconds to select all 3 zones.)
Select the program using the PGM button.
Set the program start time.
Select the mode by pressing the corresponding button.
Repeat steps 3 to 5 for the remaining programs for the selected
zone.
Go to step 2 if you wish to select another zone.
Press
TH134 will automatically exit programming if no button is
pressed for the last 60 seconds.
When selecting the number of programs,
Press the MAN/AUTO button for 3 seconds
until PPd is displayed.
Select the zone using the ZONE button.
(Press for 3 sec. to select all 3 zones.)
Press MAN/AUTO until the desired day is
displayed.
Set the number of programs for the selected
day using the
• 4 (to select all 4 programs)
• 2 (to select program 1 and 4 only)
• 0 (no program is selected for that day)
If no program is selected for a particular day, TH134 uses
the order of the last program until the start of the next program.
Repeat steps 3 and 4 for the each remaining day.
Go to step 2 if you wish to select another zone.
Press
Enter your settings in the following table.
√
√
√
√
2
2
to exit programming.
buttons. The options are:
to exit.
400-134-000-A
1/27/05
3/4