ABSTRACT Universal Kullanım Kılavuzu - Sayfa 3

DJ Ekipmanları ABSTRACT Universal için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ABSTRACT Universal 19 sayfaları.

Abstract Universal Instruction Manual

Connections and controls

All the units have the same connections and indications, though they are in
different positions on the different units. The main connections and controls
are as follows.
1.
DMX output socket (pin 3 cold, pin 2 hot, pin 1 grounded). Other DMX
devices can be linked in to the system through this socket. In stand alone
mode the unit outputs its own DMX through this socket. If you're not sure
which is the input and the output, the input is the one where you can touch
the pins, the output is the one where you can't.
2.
DMX input plug (pin 3 cold, pin 2 hot, pin 1 screen). A dedicated
controller such as the Abstract CE controller, or other DMX lighting desk
can be connected to this plug. The unit buffers the DMX signal, so you must
make sure you get the connectors the right way round. If you are using a
controller with a 5-pin DMX output, you will need to use a 5 to 3 pin
adaptor with pins 2 and 3 swapped.
3.
Power on LED (red). This LED is lit whenever the unit is powered up. If
this light does not come on there is either no power to the unit, or some
internal problem with the unit.
4.
DMX present / Audio beat LED (green). This LED is on
constantly when DMX is being received (it may flicker in time with the DMX
frames), and goes out when DMX is not received. When the LED is not lit the
unit is in stand alone mode and the LED will flash when an audio beat is detected.
Page 3
2
1
5
3 4
6