Auber WS-1500EBPM Çalıştırma Talimat Kılavuzu - Sayfa 15

Sıcaklık Kontrolörü Auber WS-1500EBPM için çevrimiçi göz atın veya pdf Çalıştırma Talimat Kılavuzu indirin. Auber WS-1500EBPM 19 sayfaları. Ws series precision pid temperature controller

Sayfayı Yazdır

Figure 9. Code 155 Parameter setup flow chart

Press and hold SET key for 4 seconds until the Parameter Window displays "LCK".

Release the SET. The display will show "0". Use "+" and "-" keys to adjust the display to

155 (another pass code) and press SET.

Setting the calibration offset. The parameter window will first show "SC "for a second

and then its value, Use "+" and "-" keys to change the setting. When finished, press the

SET again to confirm the change. For example, if the temperature is 1 °C too high during

calibration then use "-" to set the value to -1 to offset value.

Setting the output reduction. The parameter window will first show "OUt "for a second

and then its value, Use "+" and "-" keys to change OUt value to your desired limit value

and press SET.

Setting Celsius (C) or Fahrenheit (F). When SET is pressed, the display will show "C-

F" and then its value of either "C" or "F". Press "-" for C or "+" for F.