Auber SYL-23X2P Hızlı Liste

Kontrolör Auber SYL-23X2P için çevrimiçi göz atın veya pdf Hızlı Liste indirin. Auber SYL-23X2P 2 sayfaları. Pid temperature controller w/ ramp/soak

Quick list of the New Key Functions for the Ramp/Soak Model (SYL-23X2P)

The following list contains a brief description of each key function for when the controller is in

basic operation mode.

1) Mode Key (SET)

When pressed momentarily, PV display shows the current step that the program is processing.

When pressed again, the PV display shows the set time length of the current step. The SV

display shows how long the current step has run in minutes. Press again to have the display

return to the basic display mode. The PV shows the process temperature and SV can either show

the set temperature or the status of the controller (Stopped, Running, or on Hold).

Pressing and holding the mode key for two seconds will put the controller into parameter

setting mode, just like the controllers without the ramp/soak option.

2) Auto/Manual function key (A/M)

Press this key to have the controller enter step setting mode in order to set the time,

temperature and action of each step.

3) Decrement key V

Press and hold this key for two seconds to start the processing. The A-M LED will light up. Press

and hold again to hold the processing. The A-M LED will flash.

4) Increment key Λ

Press and hold this key for two seconds to stop the processing of the program. A-M LED will turn

off.

Table: Summary of new key functions

To start the processing

To stop the processing

To hold the processing

Check current step

Check run time of current step

Go to step X (jump)

To program the steps

Frequently asked questions

1. What is the difference between "Hold" and "Stop".

Hold does not stop heating. It holds the temperature at the current setting, (or at OutL). "Stop"

will stop heating. If you Hold the program (V key) and start Run (V key) again, it will start from

Press V key for 2 seconds

Press ^ key for 2 seconds

Press V key for 2 seconds

Press SET key briefly

Press SET key briefly twice

Press SET key briefly, then use V or ^ to go to

the step, press SET key to jump

Press A/M key to enter programming mode,

then press SET key to go to next step.

Auber Instruments, Aug 2015