Auber Instruments WS Series Kullanım ve Talimat Kılavuzu - Sayfa 14
Sıcaklık Kontrolörü Auber Instruments WS Series için çevrimiçi göz atın veya pdf Kullanım ve Talimat Kılavuzu indirin. Auber Instruments WS Series 18 sayfaları. Programmable pid temperature controller with dual probe
Ayrıca Auber Instruments WS Series için: Hızlı Kılavuz (15 sayfalar), Hızlı Kılavuz (14 sayfalar), Kullanım ve Talimat Kılavuzu (18 sayfalar), Hızlı Kılavuz (14 sayfalar)
Sayfayı Yazdır
SET
30
3 sec
Figure 5. Code 155 Parameter setup flow chart
Press and hold SET key for 4 seconds until the Parameter Window displays "LCK".
Release the SET. The display will show "0". Use "+" and "-" keys to adjust the display to
155 (another pass code) and press SET.
Setting the calibration offset. The parameter window will first show "SC "for a second
and then its value, Use "+" and "-" keys to change the setting. When finished, press the
SET again to confirm the change. For example, if the temperature is 1 C too high during
calibration then use "-" to set the value to -1 to offset value.
Setting the output percentage. The parameter window will first show "OUt "for a
second and then its value, Use "+" and "-" keys to change OUt value to your desired limit
value and press SET.
Setting Celsius (C) or Fahrenheit (F). When SET is pressed, the display will show "C-
F" and then its value of either "C" or "F". Press "-" for C or "+" for F.
SET
LC8
155
14
sc
SET
al
SET
fa
SET
oAL
SET
hy
SET
Cool
SET
00t
SET
C-F
SET
C8
SET
0
SET
250
SET
0
SET
0
SET
3
SET
0
SET
100
SET
F
SET
1
SET