Auber Instruments EZboil DSPR120 Kullanım Kılavuzu - Sayfa 6

Kontrolör Auber Instruments EZboil DSPR120 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Auber Instruments EZboil DSPR120 10 sayfaları. Power regulator for boiling process automation

Sayfayı Yazdır

AUBER INSTRUMENTS

Note 10. Alarm Function: bALH

EZboil has a built-in buzzer that can be programmed to beep when temperature

reaches the alarm set temperature, bALH. The alarm will generate four short

beeps every time the temperature rise from below ALH to higher than ALH. The

alarm function can be used to notify the operator when temperature is

approaching the boil. The alarm function does not affect the heating or the time

function, it only provides the alarm sound.

7. Application examples:

1. Timer operation example:

The timer can be used for several ways to help the boiling process.

1) Use it to automatically control the boiling time (boiling mode).

Set the parameter as following

tF=on, btSP=210, tdIr=dn, bEO=OFF, bt=1:30,

The timer will start to count when temperature reaches 210 degrees. The timer

will count down from 1:30, when time out, the controller will stop heating, beeps,

and flash "End".

2) Use the timer as a regular timer (boiling mode).

Set btSP below the ambient temperature so that timer is available, set bt to a

very long time so that it will not end before operator decide to end the boil. The

counting direction should be up. Use the reset button (rSt) to reset the timer at

any time

tF=on, btSP=50, tdIr=up, bEO=on, bt=60:00.

3) Use the timer as a regular timer (mashing mode).

Set tSP below the ambient temperature so that timer is available, set t to a very

long time so that it will not end before operator decide to end the mash. The

counting direction should be up. Use the reset button (rSt) to reset the timer at

any time

tF=on, tSP=50, tdIr=up, EO=on, t=60:00.

4) Use EZboil as a manual regulator (similar to DSPR1)

To use it as manual regulator with temperature reading, please set it to boiling

mode. Disable timer, and set boiling acceleration set temperature below ambient

temperature (or just zero).

Mode=boiling, tF=off, bAST=0

8. Wiring Examples

Example 1. Here are two wiring diagrams of how to connect a DC triggered AC

SSR with this power regulator.

RTD

Figure 9. Wiring examples of controlling a heater with SSR and DSPR120 in a

120VAC system (upper) and in a 240VAC system (lower).

2017.03

SSR

Heater

SSR

Heater

9. Common sensor errors:

This regulator will display error message or incorrect temperature reading if your

sensor is not connected, or your sensor is bad. Top display will flash "orAL" and

"932" alternately, if you set it to Fahrenheit display (C-F =

alternately, if you set it to Celsius display (C-F =

120V AC

240V AC

Email: [email protected] Tel: 770-569-8420

No part of this manual shall be copied, reproduced, or transmitted in any way

without the prior, written consent of Auber Instruments. Auber Instruments

retains the exclusive rights to all information included in this document.

WWW.AUBERINS.COM

C).

Auber Instruments

5755 North Point Parkway, Suite 99

Alpharetta, GA 30022

www.auberins.com

F); or "orAL" and "500"

P6/9