daltile 1020 TS Kullanım Kılavuzu - Sayfa 10
Testere daltile 1020 TS için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. daltile 1020 TS 16 sayfaları. Tile
Sayfayı YazdırThis method of positioning the cord prevents
the travel of water along the power cord and the
possibility of the water coming in contact with
the receptacle. If the plug or electrical outlet
gets wet, DO NOT unplug the cord. Disconnect
the fuse or circuit breaker that supplies power
to the machine. Then unplug and examine the
machine for the presence of water in the outlet.
It is important to use extension cords that are
only intended for outdoor use. These extension
cords are identified by a marking "Acceptable
for use with outdoor appliances; store indoors
while not in use".
It is important to only use extension cords
having an electrical rating not less than the
rating of the product.
It is important not to use damaged extension
cords. Examine the extension cords before
using it and replace it if it is damaged.
It is important to not abuse the extension cord
and do not yank on any cord to disconnect it
from the outlet.
It is important to keep the cord away from heat
and sharp edges.
It is important to disconnect the extension cord
from the outlet before disconnecting the machi-
ne from the extension cord.
It is important not to use an extension cord that
is undersized. Using an undersized extension
cord can result in low voltage to the motor thus
resulting in a motor burnout or premature failu-
re.
PAGE 10 DALTILE 1020TS OPERATING MANUAL V02/2004R1
DALTOOL SAFETY
To choose the proper extension cord;
Locate the length of extension cord
needed in the table below
Once the proper length is found, move
down the column to obtain the correct
AWG size required for that length of
extension cord.
Extension Cord Minimum Gage for Length
Volts
120V
TILE SPECIFIC WARNINGS:
Always wear eye and hearing protection.
Always disconnect the saw before conduc-
ting any type of service on the machine,
including when changing cutting blades
and cleaning.
Use the machine only with Daltool 10"
continuous rim cutting blades.
Always replace damaged cutting blade
before operating.
Total Length of Cord [ft]
25
50
AWG
AWG
AWG
14
12
Not recommended
100
150
AWG