DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center Kurulum Kılavuzu - Sayfa 10
Kayıt Ekipmanları DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center 19 sayfaları. Thunderbolt 3, dante, madi and adat modular analogue & digital audio interface
Sayfayı YazdırInstallation Guide AX Center
Installation of DAD Thunderbolt 3 driver on Windows PC
The driver software has to be installed completely in order to function properly.
When you install the driver, it is of no importance whether you have units or other peripherical devices
connected to the Thunderbolt 3 / USB-C port on the computer. In the process described below there are no
devices connected before installation.
The installation sequence is the following:
1. Copy the driver .msi windows installer file to the computer desktop and double click in order to start
installation.
2. Follow the installation instructions. Click Next and then Install.
3. Once the driver is installed, open your audio application and choose the Digital Audio Denmark ASIO
driver.
4. In order to configure the ASIO driver, open the ASIO dialogue window in the audio configuration section
of your audio application.
5. Configuration can be done on the parameters shown in figure 6.
Note. The DAD ASIO control panel is accessible as a stand-alone configuration window or if your DAW
audio application supports this, from inside the audio configuration dialogue.
Doc no. AXCNTR-8001-A-4
Figure 5, ASIO driver configuration window.
Rev. date 221023
Page 10 of 19