DAN DRYER ELEGANCE 714 Kurulum ve Kullanıcı Talimatları
Saç Kurutma Makinesi DAN DRYER ELEGANCE 714 için çevrimiçi göz atın veya pdf Kurulum ve Kullanıcı Talimatları indirin. DAN DRYER ELEGANCE 714 2 sayfaları.
Sayfayı YazdırINSTALLATION & USER INSTRUCTIONS
®
DAN DRYER
ELEGANCE HAIR DRYER TYPE 714
Enclosed with the hair dryer are the installation instructions as well as a small
plastic bag containing:
4 pcs. screws
2 pcs. rawlplugs
2 pcs. plastic cap
1 pcs. plastic hanger
COMPONENTS:
1. Dryer unit
2. Activation button
3. Switch for air temperature setting
4. Holder
5. Shaver plug (110 / 230 V)
6. Base plate
PRIOR TO INSTALLATION:
Before installing the hair dryer, please check that the network has sufficient
capacity to handle the extra wattage specified on the handle of the dryer.
Be sure to install the hair dryer in adequate safety distance from bath tub and
shower.
The hair dryer is double-insulated and thus needs no earth connection.
INSTALLATION VIA PLUG SWITCH:
➊
Mark and drill 2 holes, 125 mm apart, as
shown in Fig. 2. Use 6 mm drill. Insert the
enclosed dowels into the holes and fix the
plastic hanger enclosed in the upper
screw hole.
➋
Slide the base plate of the holder in place
onto the hanger, thus attaching the base
plate. Fix the holder onto the wall and
ENG-Monteringsvejledning Elegance 714.doc/250908
cover the lower screw hole with the cap marked
➌
The unit is ready for use when plugged in, and when the power switch is in
ON position.
FIXED INSTALLATION – ON WALL OR IN DRAWER:
➊
Mark and drill 2 holes, 125 mm apart, as shown in
Fig. 2. Use 6 mm drill. Insert the enclosed dowels
into the holes and fix the plastic hanger enclosed in
the upper screw hole.
PLEASE NOTE: When installing the dryer
in a drawer, drill 2 holes as shown in
Fig. 5. Use 4 mm drill. Drill hole for cable
entry at the back of the drawer.
➋
Loosen the screws marked on Fig. 3 and
remove the front of the holder.
➌
Disconnect the power cable that came
with the dryer from the terminal block.
➍
Press to remove the plastic bit marked
on Fig. 4 to create hole for cable entry.
Feed the cable from the wall through the hole and
slide the base plate of the holder in place
onto the hanger, thus attaching the base
plate. Connect cable to terminal block
(marked
on Fig. 4). Fix the unit onto the
wall using one of the enclosed screws.
PLEASE NOTE: For drawer installation, fix
holder directly at the bottom of the drawer
using the two screw holes placed horizontally
in the base plate of the holder. Do not use the
enclosed plastic hanger. Feed the cable from
the wall through the hole at the top of the
holder and connect to terminal block.
➎
Replace the plastic cap marked
cover the lower screw hole; then reassemble
the front of the holder.
➏
The unit is ready for use when plugged in, and when the power switch is in
ON position.
in Fig. 2.
①
on Fig. 2 to