DAN DRYER 297 Kurulum ve Kullanım Talimatları - Sayfa 2

Dağıtıcı DAN DRYER 297 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları indirin. DAN DRYER 297 2 sayfaları. Design dispenser for fluid soap / disinfectant / foam soap

Sayfayı Yazdır

INSTALLATION INSTRUCTIONS

DAN DRYER

DESIGN MANUAL SOAP DISPENSER

Select a suitable place above sink / tabletop where to mount the dispenser.

Take note to leave a minimum distance of 20 cm from sink / tabletop or like

object to the lower edge of the dispenser, so that it is easily operable both

in connection with use and soap re-fill (cf. scale drawing on the back page).

Attach the enclosed template to the wall with self-adhesive tape.

We recommend the application of Ø4 mm

screws. Depending on the relevant wall type,

holes may be rough-bored, and suitable dowels

may be used.

Remove the transparent soap container with

operating lever by pushing in the spring plate

marked 1 in Fig. 1, allowing for the soap

container to easily slide up and out of the tracks

marked 2 in Fig. 1.

Attach the back plate of the product to the wall

using Ø4 mm screws for relevant wall type.

Push in the spring plate and slide the soap

container back in place in its tracks on the back

plate.

Art. no. 296 is for fluid soap.

Art. no. 297 is for surgical spirit or similar disinfectant.

Art. no. 298 is for foam soap.

Put the lid back on the transparent soap container, close the housing

and test the operating lever a couple of times until the pump releases a

full dosage.

MAINTENANCE:

Clean the housing on the outside using a stainless steel care product. Avoid

the use of chemicals.

The pump system requires no specific maintenance, and the unit can be left

unused for longer periods of time without any problems – as long as the

transparent soap container is not left completely empty.

If, contrary to expectation, the valves of the pump system clog up, simply

pump warm water through container and pump system, thus making the unit

ready for use again.

COMPONENTS CHART:

Fig. 1

A. Soap container with operating lever

B. Housing with back plate

C. Square key

Fig. 2.