concept 2 SkiErg Montaj ve Kurulum
Fitness Ekipmanları concept 2 SkiErg için çevrimiçi göz atın veya pdf Montaj ve Kurulum indirin. concept 2 SkiErg 2 sayfaları.
Sayfayı Yazdır
Floor Stand Assembly and SkiErg Installation
Wooden
Base
1
With the wooden base
on its side, position
the universal bracket
on the base as shown.
3
Install a T-nut over the
protruding fastener and
finger tighten. Use a
hammer to fully seat the
T-nut on the fastener.
Repeat steps 2 and 3
on the opposite outside
hole and tighten both
fasteners.
(2) T-nuts
PN 2251
U-bar
U-bar bracket
Located in SkiErg box
(1) universal bracket
Page 1
Parts Bag Contents
(8) 1 1/4" fasteners
PN 2206
(4) T-nuts
PN 2251
(8) black washers
PN 1259
(6) 1/2" fasteners
PN 1231
2
Assemble a fastener
and washer and insert
through the top of the
wooden base and into
the universal bracket
in one of the outside
holes. The fastener
will protrude from
the underside of the
wooden base.
(1) 1 1/4" fastener
PN 2206
(1) black washer
PN 1259
4
From the underside of
the wooden base, insert
the two remaining
T-nuts in each of the
two inside holes of
the universal bracket.
Use a hammer to fully
seat the T-nuts. Lay the
wooden base on its
bottom in preparation
for mounting the
SkiErg.
(2) T-nuts
PN 2251
0815
(1) T27 6-lobe driver
CONCEPT2.COM