Elite Acoustics A1-58 Hızlı Başlangıç Kılavuzu - Sayfa 10
Amplifikatör Elite Acoustics A1-58 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Elite Acoustics A1-58 12 sayfaları. 120w lithium battery powered acoustic amplfier with 3 channels, mixer, and 16 digital effects
Sayfayı Yazdır
R1 - Bright Cavern
R2 - Dark Cavern
R3 - Bright Hall
R4 - Dark Hall
R5 - Bright Room
R6 - Dark Room
R7 - Bright Plate
R8 - Dark Plate
•
•
There are 16 total Digital EFX programs
•
R1 to R10 - REVERB
•
E1 and E2 - ECHO
•
ER1 and ER2 - Echo and Reverb
•
CHO - Chorus
•
FLange - Flanger
•
•
Program select Encoder (10) is for program change.
•
Parameter knob (9) to change rate or delay time for the program that is set.
•
Mix knob (8) is to fine turn the amount of EFX you want in output mix.
•
EFX can be bypassed by Pressing the bypass switch (9)
•
EFX send levels for each channel is set by on the rear panel ( 14, 24, and 31)
that correspond to each channel.
•
•
Distorted Sound
•
1) Check input level to make sure input Signal Light is in GREEN and not CLIP-
PING RED. Reduce Input by turn down GAIN knob (12, 19). Make sure all EQ
knobs are set to Middle. (FLAT)
•
2) Check Monitor Signal Light is also GREEN and not Clipping. Reduce Speaker
Level by turning Monitor Knob (3), make sure EQ is set to middle (FLAT)
•
•
No Sound
•
1) Check LED signal lights. Green means there is Signal on the input.
•
2) Make sure MIX knob is at 12 o'clock position.
•
3) Make sure Channel is un-muted.
•
4) Make sure +48V is on when using a Condenser Mic. Make sure to MUTE
when turning on +48V to prevent loud POP sound.
•
•
Battery not Holding Charging
•
1) Power unit off and charge the unit for 24 hours with Battery switch in Con-
nected position. If problem still persist, contact [email protected] for
battery replacement instructions.
•
•
DIGITAL EFX
16 DIGITAL EFX PROGRAMS
TIPS
R9 - Ambience1
R10 - Ambience2
E1 - Echo
E2 - Repeat Echo
ER1 - Echo/Rev1
ER2 - Echo/Rev2
CHO - Chorus
Flange - Flange