Airuno Aida 60 Kurulum ve Kullanıcı Talimatları - Sayfa 6

Havalandırma Davlumbazı Airuno Aida 60 için çevrimiçi göz atın veya pdf Kurulum ve Kullanıcı Talimatları indirin. Airuno Aida 60 12 sayfaları. Built-in cupboard hood

Sayfayı Yazdır

Attach hood cover inside cupboard (Fig 10).

Fig 10

3.2 Electrical Wiring

The electrical wiring must be performed by a

specialised electrician fully respecting current

standards and legislation in force. Check that the

power supply corresponds to the voltage requested

by the hood, which is given on the silver label stuck

inside the hood. Ensure that the wiring system

conforms to current standards and the earth

discharge works efficiently. Pay special attention to

the hood power cable, ensure that it does not pass

through any holes without a cable clamp. For direct

connection to the electrical mains it is necessary to

provide a device that ensures disconnection from the

electrical mains, with an opening distance of the

contacts that allows the complete disconnection

under the conditions of overvoltage category III, in

accordance with the rules of installation. The plug or

Omni polar switch must be accessible when the unit is

installed.

If the power cord is damaged, it must be replaced by

a special cord or assembly available from the

manufacturer or its service agent. The cable must be

of type H05VV-F 3 x 0.75mm

minimum cross-section.

The manufacturer declines all responsibility if the

current accident prevention standards in force are

not respected, which are needed for the wiring

system to operate correctly.