Duco DucoBox Silent 325 Kurulum Kılavuzu - Sayfa 6
Fan Duco DucoBox Silent 325 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Duco DucoBox Silent 325 12 sayfaları.
Ayrıca Duco DucoBox Silent 325 için: Hızlı Başlangıç Kılavuzu (16 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (16 sayfalar)
Sayfayı Yazdır
ENGLISH
05 Additional control options
05.A 3-position switch* via Perilex connector
The last operation on any User controller takes primacy
in all cases� The ventilation position on the 3-position
switch can therefore be overruled by another User con-
troller, such that an incorrect ventilation position will
be visible on the 3-position switch�
Please refer to the manual with the Duco Perilex plug
for more information�
* The 3-position switch is not a DUCO component�
05.B Boxsensors
Boxsensors can be built into a DucoBox Silent and provide CO
or humidity measurement in an air duct� A DucoBox Silent can
contain a maximum of one CO
living room (CO
measurement) and bathroom (humidity measure-
2
ment) are connected to the same duct/zone, the two Boxsensors
can be clipped together�
Fitting + connecting Boxsensor
Twist the Boxsensor(s) into the desired duct in the box
1
until the Boxsensor clicks home�
Connect the Boxsensors to one of the two connectors
2
provided on the DucoBox Silent PCB�
Settings
The CO
and RH setpoint can be changed using the Duco Network
2
Control Tool� See www�duco�eu for more information�
06 Electronical installation
06.A Change settings
Most of the factory settings for the network and components will be satisfactory as they are, however, depending on the situation,
it may be desirable to change some parameters, such as the CO
user-friendly software also enables problems in the system to be pinpointed� The Duco Network Tool is issued to every installer af-
ter attending a free training course at the Duco Academy*� Please refer to our website or your Duco dealer for further information�
* Only in Belgium and the Netherlands
6
L2000651 Installation guide for DucoBox Silent (Revision M | 17.07.2019)
and one Humidity Boxsensor� If the
2
and/
2
1
RH
setpoint� This can be done using the Duco Network Tool*� This
2
medium setting
low setting
CLICK
CO
2
CLICK
RH
DucoBox
high setting
2
CLICK
CO2