Anyload S2 Kullanıcı Kılavuzu - Sayfa 9

Ölçüm Cihazları Anyload S2 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Anyload S2 15 sayfaları.

• Filter Level：User can edit the number from 0~7 to selects the digital filtering

rate. The higher the value, the lower is the effect acting upon the indicator due

to noise and mechanical vibration and hence having a more accurate display.

However, it slows down the settling rate of the indicator. It is recommended to

be set to 1~4.

2.4 Other Setting

1. Default: Set all the parameter to

default.

2. Battery: Monitor the battery

voltage

3. Precis: Precision setting, when it's

enabled, press 0/F2 in the weighing

mode,

the

division

circlely.

4.Peak: Peak holding function. In

In the setting mode, press 2/TIME to Enter SYSTEM setting.

Before starting system configuration, user must input the password to enter the

setting interface, the default password is 111111, press Enter after inputting 6

digits.

In this chapter, this manual will guide you how to calibrate the indicator, set the

password, and configure other parameters setting.

In system setting, press 1/Clear to enter calibration.



Divisi : Division, Display division. Specifies the display divisions,

1,2,5,10,20,50 are available for division setting.



Decimal: Decimal point. Specifies the decimal position, 0, 1, 2, 3, 4 are

Page 9 of 15 AL‐Manual‐110ES‐WL‐S2‐En‐103

Other setting，press 4/L.F to select

this item, if there is a tick in the end,

the Peak holding is enabled. In

normal weighing mode, press 7/F1 to

activate Peak Holding, there will be a

"P" on the screen. Press 7/F1 again,

will

change

the Peak Holding function will be

turned off, "P" will disappear.