Concoa 9400 Series Kurulum ve Çalıştırma Talimat Kılavuzu - Sayfa 3

Kontrolör Concoa 9400 Series için çevrimiçi göz atın veya pdf Kurulum ve Çalıştırma Talimat Kılavuzu indirin. Concoa 9400 Series 12 sayfaları.

USER RESPONSIBILITY

This equipment will perform in conformity with the description contained in

this manual and accompanying labels and/or inserts when installed, operated,

main tained, and repaired in accordance with the instructions provided. This

equip ment must be checked periodically. Improperly working equipment

should not be used. Parts that are broken, missing, worn, distorted or

con tam i nat ed, should be replaced im me di ate ly. CONCOA recommends

that a tele phone or written request for service advice be made to CONCOA

Cus tom er Service in Virginia Beach, Virginia, PHONE: 1-800-225-0473,

FAX: 1-757-422-3125, or E-MAIL: [email protected].

This equipment or any of its parts should not be altered without prior written

ap prov al by CONCOA. The user of this equipment shall have the sole

re spon si bil i ty for any malfunction that results from improper use, faulty

main te nance, damage, im prop er repair, or alteration by anyone other than

CONCOA or a ser vice facility des ig nat ed by CONCOA.

SAFETY

Speciﬁ c procedures for the safe use of regulators are listed below. The

user can form habits that will prevent an accident due to confusion over

chang ing service needs. Refer to CONCOA publications ADE 872, latest

revision, Safe Practices in Welding and Cutting.

a. Never subject the regulator to inlet pressure greater than its rated inlet

pressure, as shown on regulator body.

b. Never use the regulator for gases other than those for which it is intended.

Check the cylinder valve outlet before attaching a regulator to a cyl in der.

Do not use the cylinder if oil, greas, or dirt is present

Do not allow oil, grease, or other combustibles to contaminate

ox y gen equipment or areas where oxygen is in use. Do not place

a con tam i nat ed regulator into service.

The regulator relief valve only protects the regulator. Downstream

equipment may require additional pressure relief devices.

d. To minimize heat effects, avoid use of piping or tubing between cyl in der

and oxygen regulator. If unavoidable, it should be as short as practicable

and equipped with a shutoff valve located just before the regulator. Keep

the shutoff valve closed when pressurizing. If reg u la tor is connected to a

manifold, open the valve of the cylinder closest to the regulator ﬁ rst, then open

the remaining cylinder valves. In either case, when the ﬂ ow to the shutoff

valve stops, wait 60 seconds and then slowly open the shutoff valve. DRAIN

OXYGEN REG U LA TOR OF GAS BEFORE PRESSURIZING.