ABTECH SAFETY ACCESS Kullanıcı Kılavuzu - Sayfa 2

Güvenlik Ekipmanları ABTECH SAFETY ACCESS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ABTECH SAFETY ACCESS 2 sayfaları. Sit harness

ABTECH SAFETY ACCESS Kullanıcı Kılavuzu
USER MANUAL
Instructions for use
All users or those responsible for the user should read and understand these instructions.
All users or those responsible for the user should be suitably trained to use this equipment.
Working load limit: 200kg. Minimum working load: 30kg
Maximum height: 2.0 metres Minimum height: 1.2 metres
The documentation issued with this harness (instructions, record card) should be kept with the
harness.
Anchor points
This harness is designed to be attached to a
system that is designed with anchor points of
sufficient strength and stability to safely support
the load applied.
Chemical attack
The harness should be kept away from acids,
alkalide, chemicals, sharp edges and anything
which may cause damage to it.
Storage and Transport
This harness must be transported and stored in
a dry cool place. Wet or damp equipment
should be allowed to dry naturally.
Inspection
This harness must be inspected at regular
intervals by a competent person. The
frequency of the inspection is dependent on the
type of usage and any prevailing conditions.
Obsolescence
Provided that the product is inspected and
maintained in accordance with manufacturers
recommendations the maximum lifespan of the
product is 10 years from the recorded first use.
The type of use and the conditions will affect
the lifespan of a product.
Cleaning
Wipe webbing with a damp cloth. If the dirt is
more ingrained wash in water up to 40 degrees
C. Use mild detergent. Rinse in clean water.
Hang up to dry. Avoid direct heat source when
drying.
Before Use
The user should make a visual inspection of
the harness. Look for damage to webbing
particularly under and around buckles and
attachment points. Check webbing for
abrasion, cuts, wear, deformation and chemical
contamination. Check stitch patterns for broken
or loose stitches, cuts and pulling. Check the
correct operation of any moving parts.
If there is any doubt as to the condition of the
harness it must be removed from service. A
further inspection should then be carried out by
a competent person or the manufacturer.
A rescue plan should be in operation.
Warning
No repairs, alterations or additions should be
made to this equipment without consultation
with the manufacturer.
The equipment should not be used outside its
limitations, or for any purpose for which it is not
intended.
Attachment Point
The harness must only be used with
attachment lanyards of suitable strength.
Abtech Safety Ltd, 1&2 Parkway Business Centre,
Sixth Avenue, Zone 2, Deeside Industrial Estate,
CH5 2LE
Tel: +44 (0)1244 837 050
Fax: +44(0)1244 837 051
www.abtechsafety.com
ITEM
SERIAL NUMBER
INSPECTION RECORD
JOB USAGE
INSPECTED BY
USERS NAME
DATE OF PURCHASE
DATE FIRST USED
COMMENTS
DATE