AnyTone AT6200 GW Kurulum Kılavuzu - Sayfa 11

Tekrarlayıcı AnyTone AT6200 GW için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. AnyTone AT6200 GW 19 sayfaları. Mobile signal repeater

7. Repeater Installation

7.1.1. Installation Location Requirements

1. The repeater shall be installed indoor in a cool, dry and ventilated room without erosive gas or smoke, or on a cool

and ventilated wall to ensure excellent heat dissipation.

2. Installation height should be sufficient for RF cable wiring, heat dissipation and maintenance.

3. Independent and stable power supply is necessary.

7.1.2. Power requirement

Generally AC 100~264V AC / 50±5Hz power supply is required.

7.2.1. Installation schemes

INSTALLATION STEPS

1. Find an appropriate position for an outdoor antenna. (see the requirements in 6.1. sect. )

2. Plug in the outdoor antenna to the mobile booster from BS side and fasten tightly.

3. Plug in the indoor antenna to the mobile booster from MS side and fasten tightly. (see the requirements in 6.1. sect)

4. Connect the signal booster to the Power Supply.

!Some models have an inbuilt Power Supply. Please, examine the manual applied to your model, if your signal

repeater kit doesn't include separate Power Supply, skip this step!

If the light indicator on the booster turns on it means the installation has been implemented correctly.

NOTE: Switch on the signal booster only after you connect outdoor and indoor antennas in the proper way!

5. Test the signal of your mobile telephone – a maximum quantity of bars should be indicated on the display of your

phone in each corner of the location within booster coverage zone. In case the mobile signal is still instable try to

change the position of the outdoor antenna for more proper one.

Important notes for installation:

1. Cables from outdoor antenna should not be wound and be placed as straight as possible in order not to create any

hindrance for signal reception and its transmission.

2. Cables should be shortened to the acceptable maximum so that not to waste or decrease mobile signal coverage

range.

3. In order to prevent water from coming into the mobile phone booster through the cable make a loop in it.

4. Keep the outdoor antenna as far as possible from frequency aerials, high voltage cables, metal nets or transformers.

5. Never point the front of a Directional outdoor antenna towards the indoor antenna.