AnyTone MyAmplifiers V-15W Kurulum Kılavuzu - Sayfa 13
Genişletici AnyTone MyAmplifiers V-15W için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. AnyTone MyAmplifiers V-15W 20 sayfaları. Mobile signal repeater
Sayfayı Yazdır7.3. Repeater Settings
7.3.1. Indicator Light Instructions
Power on, check ALARM and POWER indicator
Power indicator status:
Indicator
Green
Orange
No Light
Alarm indication status:
Indicator
Phenomenon
Alarm
low (No
light)
Alarm
low
(Green)
Alarm
low
Orange
(flashing)
Alarm
High (No
light)
Alarm
High
(Green)
Alarm
High
Orange
(flashing)
Phenomenon
DC power is normal
Shut off, pls take out power supply and power on again
DC power with problem
No communication in repeater
coverage or indoor antenna
didn't receive signal
Work in coverage
Signal is too strong from
outdoor antenna or repeater
self -oscillation. Alarm low is red
or flash in 5s, downlink will stop
in 1s. Repeat above status,
repeater will power off, power
light is orange. User should take
off power supply and power on
again.
Weak signal from outdoor
antenna
Work in coverage
Signal is too strong from
outdoor antenna or repeater
self -oscillation. Alarm low is red
or flash in 5s, downlink will stop
in 1s. Repeat above status,
repeater will power off, power
light is orange. User should take
off power supply and power on
again.
Solution
Disconnect repeater and outdoor antenna,
connect load in port of outdoor antenna. it
means isolation is low between outdoor and
indoor antenna when orange light is off,
please adjust isolation. If red light is on, it
means outside signal too strong from outdoor
antenna or strong interference, please adjust
outdoor antenna direction.
Disconnect repeater and outdoor antenna,
connect load in port of outdoor antenna. it
means isolation is low between outdoor and
indoor antenna when orange light is off,
please adjust isolation. If red light is on, it
means outside signal too strong from outdoor
antenna or strong interference, please adjust
outdoor antenna direction.