Dudek Techno Kullanıcı Kılavuzu - Sayfa 13

Aksesuarlar Dudek Techno için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dudek Techno 19 sayfaları. Light harness with a pod

Pulling the release handle simultaneously opens both the frontcontainer and the pod. In this case the balls closing the

pod can get lost, so it's worthwhile to carry the additional set along (it's in the pod's equipment). It can be also

purchased

7. Harness/paraglider connection

Techno harness is equipped with aluminium carabiners Dudek of 20 kN strength. Use them to connect the harness to

the risers. Another thing to connect before launch is the speedsystem of the harness with the speedsystem of the

risers. It is recommended to replace the main carabiners with new ones each 300 hrs airtime.

! !

Before launch check if the carabiners are closed and locked against accidental opening.

The only safe way of attaching the tow line is a dedicated tow release. The Techno does not feature any additional

points to fix the tow release, therefore it is to be mounted directly on the harness' carabiners or the canopy risers.

! !

Before adjusting the straps please install rescue chute and fill the back pocket as for normal flight. Watch

out for symmetry – left and right side should be adjusted the same. First, test flight should be done in

easy weather conditions, with necessary corrections to be applied afterwards.

Do not adjust the speedsystem lines in flight.

9.1 Shoulder straps

Thanks to adjustable shoulder straps the harness can accommodate pilots of almost any height. The straps should

stay on your shoulders rather tight, with just a little play. Too short straps will make difficult comfortable seating after

launch and can limit your movements in flight. A clip on the shoulder traps will make sure they stay in place during

launch and flight. Additionally, there is an alarm whistle fixed to the clip.

Buckles for adjusting

shoulder straps