Anyware Instruments Moodulator Kullanıcı Kılavuzu - Sayfa 7

Sentezleyici Anyware Instruments Moodulator için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Anyware Instruments Moodulator 19 sayfaları.

no matter where in its phase it is at that particular moment.

If both oscillators are tuned in unison, then they'll be perfectly in tune and there won't be any beating.

The same will happen if the slave is tuned to any position within the harmonic scale,

(that is x2, x3, x4, x5, etc). Octaves will be x2, x4, x8, etc.

For classic hard sync sounds, the slave oscillator has to be modulated by an envelope or an lfo. On the

MOODULATOR, the best way is by modulating OSC2 with the Mod Env, either as an envelope or in lfo mode.

On the "Mod env amount" section on the panel, use "osc2 fm" knob to define the depth of the modulation.

The two way switch works as follows:

OFF:

Turns off hard sync.

ON:

Turns on hard sync, now both oscillators

are synchronized.

OSCILLATOR FM SOURCE SELECT (switch)

This is a three way switch which selects the modulation source for oscillator's pitch.

The modulation depth is defined by the OSCILLATORS FM knob.

LFO:

LFO modulates both oscillator's pitch, defined by the OSCILLATORS FM knob.

WHEEL→ LFO

: Pitch of both oscillators are modulated by the LFO.

Depth is defined by a combination of the OSCILLATORS FM knob and the modulation wheel.

AMP ENV :

Pitch of both oscillators are modulated by the amplitude envelope.

Depth define by the OSCILLATORS FM knob.

OSCILLATORS FM (knob)

This knob defines the modulation depth for the oscillators.

The modulation source is selected with the OSCILLATOR FM SOURCE SELECT switch.

OSC 1 PWM (PULSE WIDTH MODULATION) (knob)

This knob defines the modulation depth of oscillator´s 1 pulse width by LFO.

Oscillator 1 has to be set to Square wave to hear the effect.