Anywave ATSC 560W DTV Hızlı Başlangıç Kılavuzu - Sayfa 7
Verici Anywave ATSC 560W DTV için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Anywave ATSC 560W DTV 13 sayfaları.
3 TX System Overview
Final assembly and test of each transmitter is performed at the Anywave factory.
The Exciter is setup on the desired channel frequency and the TX is tested with the
complete RF system (if purchased) at full power into a load. All TX operating
parameters are optimized and the Transmitter Forward and Reflected power meters are
properly calibrated. Linear and Nonlinear precorrection is performed and automatically
stored in non-volatile memory inside the Exciter. A Factory Test Report is completed
for each system, providing a record of full power operating parameters and performance.
The TX then goes through a final 24-hour burn-in period and check out before being
shut done and packed up for shipment.
In your shipment, you should receive a copy of the following documentation.
- Packing Checklist
- Transmitter Factory Test Report
- 560W TX Quick Start Guide
- 560W PA and Exciter User Manuals
Carefully unpack and inspect all your equipment and please review the Packing
Checklist when you receive your system to be certain you have received all your system
components. Also, please be sure to identify and remove all packing materials and
supports (foam pads, etc.) prior to initial turn on of the equipment.
All Single PA TX systems ship with an AC power cord included with the Exciter
and PA. The PA shipment also includes an RS232 cable, for Exciter to PA
communications, and a CAT5 Ethernet cable, for Exciter to PC built-in web interface
Remote Monitoring and Control.
ACT-560-QSG-DOC-V1.2, 10/10/2014
ATSC 560W TX Quick Start Guide
Page 7 of 13