DUDOFF TP-Z01 Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 9

Setüstü Ocak DUDOFF TP-Z01 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. DUDOFF TP-Z01 12 sayfaları. Teppanyaki

Sayfayı Yazdır

5) ELECTRICAL CONNECTIONS

IMPORTANT: the appliance must be

installed following the manufacturer's

instructions. The manufacturer will not be

liable for injury to persons or animals or

property damage caused by an incorrect

installation.

The electrical connection must be made in

conformity with current rules and regulations.

Before making a connection, check that:

- the voltage matches the value shown on the

specification plate and the section of the wires of

the electrical system can support the load, which

is also indicated on the specification plate.

- The capacity and outlets of the electrical

installation are suitable for the maximum power

output of the appliance (see the information label

attached on the underside of the housing).

- The outlet or installation is provided with a

ground connection according to standards and

provisions currently in force. All responsibility is

declined for failure to comply with these

provisions.

- If a power cord is not supplied with the appliance,

connect a cable with a suitable section to the

terminal board (see the table in paragraph 6)

keeping the ground wire longer than the lead

wires in conformity with the diagram in fig. 8.

When connection to the power circuit is made

through an outlet:

- apply to power cable "C", if not provided, a

standard plug suitable for the load indicated on

the information label. Connect the wires as in the

diagram in fig. 8 taking care to observe the

responses listed below:

letter L (phase) = brown cable;

letter N (neutral) = blue cable;

symbol

(earth) = yellow-green cable.

- The power cord must be placed in a way that it

does not reach an temperature of 90 °C in any

position.

- To connect, do not use adaptors or switches as

they may cause false contacts resulting in

dangerous overheating.

- The outlet must be accessible after the built-in.

When connection is made directly to the power

circuit:

- place a switch between the appliance and the

circuit of an appropriate size for the load of the

appliance and with a minimum aperture between

contacts of 3 mm.

- Remember that the earth cable must not be

broken by the switch.

INSTALLATION

- The electrical connection may also be protected

by a high sensitivity differential switch.

It is strongly recommended that the yellow-green

earth cable provided be connected to a good earth

installation.

Before performing any service on the electrical

part of the appliance, it must absolutely be

disconnected from the electrical network.

If the installation requires modifications to

the home's electrical system or if the

socket is incompatible with the appliance's

plug, have changes or replacements

performed by professionally-qualified

person. In particular, this person must also

make sure that the section of the wires of

the socket is suitable for the power

absorbed by the appliance.

WARNING:

all of our appliances are in compliance with

European standards EN 60 335-1, EN 60 335-2-6

and relative amendments.

This appliance satisfies the requirements of

European directives:

- CEE 2004/108/CE concerning electromagnetic

compatibility.

- CEE 2006/95/CE concerning electrical safety.

- CEE 2011/65/UE on the restriction of use of

certain hazardous substances.

- Regulation (EU) No. 66/2014 supplementing

Directive 2009/125/EC.

Standards EN 60350-2.

FIG. 8