Anywire DB A40 Series Manuel - Sayfa 2
Kablolar ve konektörler Anywire DB A40 Series için çevrimiçi göz atın veya pdf Manuel indirin. Anywire DB A40 Series 15 sayfaları. Link connector insulation displacement method of flat cable
Sayfayı Yazdır
Caution Items
The cautions to this manual
1. This manual should be sends to last user.
Please perform operation of this product after often reading this manual and understanding the
contents.
2. This manual explains the functional details included in this product, and does not guarantee
suiting a visitor's specific purpose.
3. Reproducing and reproducing some or of this device without notice refuses.
4. It may change without a preliminary announcement about the contents of this manual in the
future.
Warnings
WARNING
！ ！ ！ ！
CAUTION
！ ！ ！ ！
In order to use it safely
！ ！ ！ ！
WARNING
！ ！ ！ ！
CAUTION
i
"Warning" shows the contents a possibility of getting death or seriously injured is
assumed to be, when handling is mistaken.
"Caution" indicates that the failure to follow this instruction can result in
minor injury or property damage.
- An AnyWire system is not a thing having a control function aimed for safe
security.
- When as follows, while having care special about safety measures which had a
margin to rating and a function and to be used, such as a way and fail-safe,
carried out, please consult to our company.
(1) The use for which high safety is needed
- The use it is predicted to be to have big influence to a human life or
property
- Device for medical treatments, device for safe, etc.
(2) When used for the system by which higher reliability is demanded
- Use to vehicles control, combustion control device, etc.
Please be sure to turn off a system before installation or exchange work.
Please use an AnyWire system within the limits of the specification and the
conditions that were set to this manual.
Be sure not to turn on the 24V power before completing wiring and connecting
in AnyWire System.
Use a regulated power supply of 24V DC. Non-regulated power supply may
cause a trouble to the system.
Keep transmission cables and I/O cables away from high-voltage and power
cables, though the AnyWire System has high noise margin.
Be careful not to allow metal bits into the unit, the connectors or the terminal
blocks, especially when wiring.
Mis-wiring may cause failure. Consider the length and installation of cable
wiring to keep connectors and cables from disconnecting or excessive
distortion.
Never solder the stranded wire to be connected with the terminal block,
otherwise causing a defective contact.
In case of long cable length of power line along the transmission lines, large
voltage drops will occur and may cause voltage shortage for the distant Slave
Units. In that circumstance, connect the local power supply units so that the
prescribed voltage is secured at each local Slave Unit.