Anzzi SD-AZFL06001 Series Kurulum ve Kullanım Kılavuzu - Sayfa 9

Banyo Armatürleri Anzzi SD-AZFL06001 Series için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Anzzi SD-AZFL06001 Series 16 sayfaları. Glass shower door

Sayfayı Yazdır

INSTALLATION STEPS

Step 1

• This shower door must be installed into a

stud. Minimum threshold space is required.

IMPORTANT: Using a stud finder,ensure that

the wall on both side of the enclosure has a

stud in the location shown. A stud in this

location must be identified to support the

support bar in order to proceed with the

installation. If you do not have a stud in this

area shown, find a qualified person for advise.

{Fig 1)

1. Place the Wall Jamb[03] to the intended

position.Make sure the Wall Jamb[03] is

resting on the floor or base and is level.

The end that should be resting on the floor

has a 45

angle. Mark the center of the holes

on the wall for the mounting screws.

Step 2

1. Remove the Wall Jamb[03] and drill hole

05/16"X1-9/16"(8X4Omm) into the wall

where marked. Place Wall Plugs [01] inside

the holes.

2.lf needed, a rubber mallet can be used to

insert Wall Plugs[01].

3.To reduce risk of property damage, the use

of metal hammers is not recommended. If

needed, use drill to slightly enlarge the

opening of the hole.IMPORTANT: Wall Plugs

[01] MUST be used.

MARK THE HOLES ON

THE WALL

LEVEL

-FLOOR

Fig 1