Danby Fresh DFG24 Kullanıcı Kullanım ve Bakım Kılavuzu - Sayfa 6

Çim ve Bahçe Ekipmanları Danby Fresh DFG24 için çevrimiçi göz atın veya pdf Kullanıcı Kullanım ve Bakım Kılavuzu indirin. Danby Fresh DFG24 9 sayfaları. Eco home herb grower

Sayfayı Yazdır

Operating Instructions

OPERATING INSTRUCTIONS

will arrive fully assembled (will it?)

The Danby Fresh Grower

and ready to use. Ensure that

you plug the power cord into a 3 prong grounded outlet.

The fan in the unit will run continuously to ensure that your plants have adequate fresh air. The fan

can only be turned off by unplugging the unit.

Two metal wire shelves are included with the unit that can be removed and adjusted to different levels

to accomodate different growing heights. Please use caution when removing a shelf as it may be un-

balanced, heavy or contain residual water. Do not remove shelving without ﬁ rst removing everything

on the shelf.

Timer function

The timer can be used to create a regular light and dark cycle for your lights just as they would re-

ceive outside. The timer will turn the light on and off as required based on the settings you choose.

Keep in mind that different plants will grow best under different light cycle conditions; some need

more light and some need less. We recommend checking the seed packet for informaiton on the best

light cycle to choose for your plants.

The circular face of the timer can be turned clockwise to set the current time. The current time is indi-

cated by aligning the arrow on the timer face with the corresponding hour of the day.

Based on the type of plants you are growing, decide at which hours you would like the light to be on

and off. Around the outside of the timer face are buttons which encompass 15 minutes of time each.

To set the time, press down each button during the time frame that you would like the light to remain

on.

Ensure that you plug the timer into a 3 prong grounded outlet and then plug the power cord of the

grower into the timer. Ensure that the switch on the top of the timer is set to "timer on".

You can change the hours that the light is on or off at any time by pulling up or pushing down the but-

tons around the outside of the timer face.

Growing tips

There are two switches on the LED light system which will provide different types of light depending

on what stage of growth your plants are in.

The Growth setting is best used when your plants are seedlings or in the early phases of growth.

When your plants are big enough to ﬂ ower and bloom, turn on both the Growth and Bloom buttons

to provide the full spectrum of light. The length of the growth and blooming growing cycles will vary

depending on what type of plants you are growing.

In general for most herbs and vegetables, we recommend the following light cycles:

Growth cycle: 18 hours on / 6 hours off or 20 hours on / 4 hours off for approximately 20 to 30 days.

Bloom cycle: 12 hours on / 12 hours off for approximately 20 - 30 days.

Typically most herbs and vegetables have a maturity date between 45 - 90 days. How long your

plants take to mature will vary based on what type of plants you are growing.

Note: Danby Products Ltd will accept no liability for any lost plants or weak harvests based on inap-

propriate use of the timer and light system.